Fascia Trimming When Installing Curt Front Mount Hitch # C31018 On 2015 Ford F-350
Question:
Do you have any suggestions for making the cut out on the air dam without cutting complete from the bottom, but instead leaving that edge intact and only making a square hole for the receiver?
asked by: Keith S
Expert Reply:
The Curt Front Mount Trailer Hitch Receiver # C31018 is confirmed to fit your 2015 Ford F-350 if you have the 4WD model. The hitch center section can be installed in either a raised or lowered position. If you mount it in the lowered position, the receiver will rest below the front fascia and won't require any trimming or modification. If you want to mount it in the raised position, this will require that a section of fascia be removed for the receiver to protrude through.
If you plan on mounting the hitch in this manner, I recommend simply holding the center section in position as if ready to install and marking the area where the receiver tube will go through the fascia. You can then cut a square opening, leaving the bottom edge intact, by using a rotary tool or jigsaw.
I have attached the written installation instructions that you can also take a look at.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Front Mount Hitch
- Q&A: Comparing the Curt Front Hitch C31018 and Draw-Tite Front Hitch 65049 for a 2012 Ford F-250/350
- Shop: Access Toolbox Edition Soft, Roll-Up Tonneau Cover
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Pace Edwards Switchblade Retractable Hard Tonneau Cover - Aluminum and Vinyl - Black
- Shop: HappiJac Camper Tie-Downs - Custom Bed and Bumper Mount - Front and Rear
- Shop: Camper Tie-Downs
- Shop: Tonneau Cover
- Shop: Nerf Bars - Running Boards
- Search Results: curt front receiver hitch
- Search Results: front receiver hitch
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Video: Curt Front Mount Trailer Hitch Installation - 2014 Ford F-250 and F-350 Super Duty
- Search Results: hr1500
- Search Results: 65049
- Shop: Hollywood Racks Sport Rider SE Bike Rack for 2 Electric Bikes - 2" Hitches - Frame Mount
- Search Results: 44649
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: 68149
- Shop: Trailer Wiring
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Fifth Wheel Hitch
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Search Results: 25580