Installation of Electric Step Motor when Utilizing 6 Spacers of Original Motor

Question

Question:

I need a diagram or explanation of where and hows the 6 spacers go. They dropped out of place when I removed the existing one. Im a regular customer. Thanks

asked by: Edward N

1

Helpful Expert Reply:

The Replacement Motor for Lippert Electric Coach Step # LC301695 may use the Replacement Spacer for Lippert Electric Coach Step # LC128958 to help keep the motor properly suspended. They are just used for the screws to thread properly and make sure the gears are in the correct location for the motor. I've attached a photo to assist.

expert reply by: Jason S

1

click to enlarge

Answer 1

Thank you for the diagrams and all of the info. It actually looks like you are missing an additional 2 spacers. If you check out the attached photos you can see that the part 38 in the instructions calls for a quantity of 6 and that you put 2 on each…

view full answer...

Answer 2

Yes you'll be able to replace your WF-600 TH-112 power inverter with the Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch - Remote - 1,000 Watts - 12V #PD94FR. The only thing you might have to change is the gauge of wire running…

view full answer...

Answer 3

Replacement Motor with Gear and Table for Kwikee 24 and 25 Series Electric RV Steps #LC369529 is my recommendation to replace your gear assembly and motor. The Replacement Link Assembly for Kwikee 24 and 25 Series Electric RV Steps #LC369488 is the…

view full answer...

Answer 4

The correct replacement control model for the SCS/Frigette Coach Step Controller part 202-3230 is the Replacement Control Module for Lippert Electric Coach Step part #LC301702.

view full answer...

Answer 5

Sounds like you have a 25 Series Kwikee RV step so for that the correct motor is the part #LC369506 and then the gear you'd need is part #LC369354.

view full answer...

Answer 6

The step motor 59734-20 will need to be replaced with the Replacement Motor for Lippert Electric Coach Step part #LC301695.

view full answer...

Answer 7

I think that your level of comfort in doing this repair lies with your level of comfort in doing electrical work-if you'd be comfortable doing electrical work at your home, this probably isn't a huge undertaking. If it's not something…

view full answer...

Answer 8

No, the Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch #PD64FR cannot be wired to run without the internal transfer switch. If you are needing a pure sine wave inverter without a transfer switch, you can use a Go Power inverter like…

view full answer...

Answer 9

The height and outer diameter of the Replacement Spacer for Lippert Electric Coach Step #LC128958 that you referenced is 1/2 inch.

view full answer...

Answer 10

The issue you described sounds like a faulty control module. In order to replace this you will want to use the Replacement Control Module for Lippert Electric Coach Step part #LC301702 which is a direct fit for your Lippert Steps 128980. I spoke with…

view full answer...

Answer 11

If you have confirmed that the motor in your Lippert or Stromberg Carlson powered RV steps is good and that there are no mechanical issues with the step linkage (that could be causing the step to sometimes stop before extending completely), then the…

view full answer...

Answer 12

The correct replacement for your old Lippert 163033 Step is the Kwikee Electric RV Step Complete Assembly #LC3691461. This kit is the complete assembly so it'll have everything you need to replace your old worn out one. I've attached a video…

view full answer...

Installation of Electric Step Motor when Utilizing 6 Spacers of Original Motor

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching