Vent Lid Replacement for a 1995-1996 Dutchmen Pop-up Camper

Question

Question:

I need a roof vent for I believe a 1995 or 96 Dutchmen POP-UP do u know where I might can find one? Sending pictures of Hinge and vent .

asked by: Gary H

0

Expert Reply:

Most likely we have what you are looking for but you will need to first determine what vent style you have on your trailer.

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14".

To pick the correct cover, you will also need to know the type of hinge you need.

There is a 3 point hinge, such as the one on the Camco # CAM40153; a 4 point hinge as seen on the Camco # CAM40154; or a rolled metal continuous hinge like on the Ventline # BVD0449-A03; and universal hinge as shown on the MaxxAir # MA00-335001.

Basically the easiest way to select the correct replacement cover is to remove the existing cover and match the hinge and lift bracket to the photos on our site along with the dimensions. A link to all of the replacement vent covers is provided to match up with your cover.

If it is not clear which hinge style that you have, the MaxxAir above is a Universal Replacement Lid.

In the event that you don't find a lid you like, I also included a link to our main page for our complete 14 x 14-inch vent assemblies. These are offered in manual or powered lift and with or without fans. If you install a complete new vent you'll need an installation kit, either # 344270KITW for a metal or coated metal roof or kit # CAM25013 for a rubberized roof..

expert reply by: Jon G

0

click to enlarge

Answer 1

I wish there was a database that had all of the replacement parts for older trailers like yours, but the only way I can recommend a replacement cover for you trailer would be to have you check out and measure yours first so you can compare it to what…

view full answer...

Answer 2

I attached a picture that shows how much of the etrailer.com hitch part #E98901 would hang below the rear bumper when installed.

view full answer...

Answer 3

The Hopkins tow bar wiring harness #HM59VR that you referenced is the same as the Hopkins part number 56209 and is for sure a confirmed fit for your 2018 Jeep Grand Cherokee. We sometimes have to change part numbers because more than one manufacturer…

view full answer...

Answer 4

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 5

Entry door locks, like the Bauer Products #BA64FR, typically will have a sticker on the inner handle portion that sits inside your RV, but I have installed a few where they also have the key code on a sticker on the inner components of the handle.…

view full answer...

Answer 6

In order to properly measure your RV's vents, you will want to measure the size of the rough opening in your RV's roof. This can be measured by removing the garnish around the vent on the inside of the RV and measuring the size of the rough…

view full answer...

Answer 7

To determine the correct cover, you will need to measure the vent opening. The most common openings are 14 1/4" x 14 1/4", and have vents that are 14" x 14". After you make your measurements, you will need to determine what type…

view full answer...

Answer 8

To determine which replacement lid you need you will need to check the hinge on the roof of your vent lid. I have included an chart that has the most common lids and shows the hinges. Once you identify the hinge you will need one of the following…

view full answer...

Answer 9

I am a big fan of tankless water heaters, especially for campers that used for boondocking, off-grid or whichever term you choose. Connected or not connected to shore power, this is a great option. I like the on demand feature that provides as much…

view full answer...

Answer 10

There are three types of hinges for replacement roof vents: 3 point, 4 point, and continuous. Replacement #BV0534-00 has a closed round hinge, which is continuous. It sounds like you need either a continuous hinge that is not closed such as…

view full answer...

Vent Lid Replacement for a 1995-1996 Dutchmen Pop-up Camper

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching