Minimum Roof Thickness of the Fan-Tastic Vent Roof Vent Part # FV802250

Question

Question:

Does this vent fan have a minimum roof thickness requirement? I’d like to install one in a Shasta Compact where the roof thickness is only about 1-3/8”. Thanks!

asked by: Charlie

0

Expert Reply:

The minimum roof thickness that the Fan-Tastic Vent Roof Vent part # FV802250 can be installed on is 1-1/2". However, since you are only 1/8" of an inch off of the manufacturer's specification you could more than likely trim the supplied garnish or add a bit of weather stripping around the flange in order to achieve the 1-3/8" thickness on your roof.

I have attached a review video for you as well.

expert reply by: Conner L

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 5

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 6

Hey Paul, we have a Blue Ox base plate kit that fits your 2024 Nissan Versa with the part #BX1856. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle.…

view full answer...

Answer 7

Hey Bruce, for a replacement Fan-Tastic brand RV roof vent I really like the part #FV803350 as it has a variable speed, reversible fan, a built in thermostat, power lid lift, and a rain sensor to auto close it in case it starts raining. The only…

view full answer...

Answer 8

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this point…

view full answer...

Answer 9

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...

Minimum Roof Thickness of the Fan-Tastic Vent Roof Vent Part # FV802250

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching