Thule Spare Me Pro Frame Cradle Strap Recommendation

Question

Question:

Will these replacement straps fit a Thule Spare Me Pro?

asked by: M. S

1

Helpful Expert Reply:

Yes, the replacement strap part # TH534 is the correct strap for the Thule Spare Me Bike Rack part # TH963PRO.

expert reply by: Jameson C

1

Answer 1

The Thule Spare Me Bike rack part #TH963PRO and the Yakima Spare Tire part #Y02599 both do come with locks to secure the rack to your spare tire and cable locks to secure the bikes to the carrier. The biggest difference between the two and is only…

view full answer...

Answer 2

I spoke with my contact at Thule and the cradles like in the picture you have provided are no longer available. However, the T3 cradles, #853-5829, and strap, #753-3535, will fit in place of the original cradles.

view full answer...

Answer 3

I called Thule and they confirmed the correct strap for your Thule spare Me 963XT is the Replacement Rubber Strap T2 Bike Carrier Cradles #753-3535. The Replacement Straps for Cradles on Thule Bike Racks #TH534 is not a fit your Thule Spare Me 963XT…

view full answer...

Answer 4

You can definitely send in a picture for me to verify a tow mirror fit for your 2003 Ford E-350. If you have manual mirrors then you should be able to use the K-Source part #KS61202F for the driver side and part #KS61201F for the passenger side. If…

view full answer...

Answer 5

According to the owner's manual for your 2012 Toyota Prius V, "Toyota does not recommend towing a trailer with your vehicle. Toyota also does not recommend the installation of a tow hitch or the use of a tow hitch carrier for a wheelchair,…

view full answer...

Answer 6

At the end of the arms of the Thule bike racks that use the Hold Fast Cradle #7521513002 there are end caps that have to be removed in order to remove the old cradles and put on the new ones. These caps can either have a screw holding them on, or in…

view full answer...

Answer 7

At the ends of the arms on Thule bike racks that take the Hold Fast cradle #7521513002 there are end caps that usually have to be removed in order to remove the old cradles and put on the new ones. These caps can either have a screw holding them on…

view full answer...

Answer 8

The fittings of the MB Sturgis Sturgi-Stay T-Fitting w/ Hose for POL Valve #103609-MBS do not require any teflon tape when installing. They have rubber gaskets built into them to provide the seal.

view full answer...

Answer 9

Your Pro Series Translite 4 Bike Rack PS63144 arms have a diameter of 1-inch. The exact replacement parts aren't available for this bike. The best option to replace your rubber cradle is a Stay-Put Cradle #853-7887 because it will also have a…

view full answer...

Answer 10

Installation of the T3 cradle replacement strap is pretty straight forward. You will need to remove the end cap from the end of the bike support arm, a Phillips screw typically holds the cap in place. Next use a small amount of soap and water to help…

view full answer...

Thule Spare Me Pro Frame Cradle Strap Recommendation

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching