Recommended Handrail for Use with Lippert SolidStep Assembly

Question

Question:

Is there a hand rail available that attaches to the step system?

asked by: Mark

1

Helpful Expert Reply:

There is a handrail available that will attach directly to the Lippert StolidStep Assembly # LC791572 and it is the Lippert entry Assist Handrail # LC799640.

We also have options that will attach to the trailer/RV that will work well. I recommend taking a look at the Stromberg Carlson Lend-a-Hand Folding Grab Handle # AM-533. This 37 inch x 25-1/2 inch rail will mount to either side of your door to offer stability as you climb the steps. It features locking mechanisms that secure the handle in the open position for use or in the stowed position for travel.

I have attached a short video demonstration on this handrail that you can also check out.

expert reply by: Chris R

1

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The SolidStep Manual Fold-Down Steps part #LC791572 will fit a door way from 25" -28.9" wide when measuring the frame inside. If the factory label sticker shows a doorway width between 26"-29" then the above steps will work for…

view full answer...

Answer 4

In terms of choosing a Lippert Solid Step, you'll use the width of the finished door at it's narrowest. Round that number up to the next full inch, which in your case would be 28 inches. In that case, you'll want the adjustable model…

view full answer...

Answer 5

Yes, the #TLD2142 is exactly what you need for your 2019 Ram 3500 with running boards extending under the truck bed. For the rear, you need the #TLD3112 if you have the factory hitch or #TLR3510 if you have the TorkLift SuperHitch Magnum 30K.

view full answer...

Answer 6

We've seen this issue before on an older camper that had the screen door installed a little lower than how they are now. An installer here actually had this exact problem. If your door is close to closing, a couple suggestions that you can try…

view full answer...

Answer 7

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

view full answer...

Answer 8

Thank you again for ordering with etrailer.com, we appreciate your business. I have attached a scan of the installation instructions for the Dexter Trailer Springs Over-Under Conversion Kit, #K71-384-00.

view full answer...

Answer 9

The SolidStep Manual Fold-Down Steps are a great choice for your Jayco 5th Wheel Camper. The amount of steps needed depends on your entry way height from the ground. The SolidStep Manual Fold-Down Steps for 26" to 29-7/8" RV Door Frames…

view full answer...

Recommended Handrail for Use with Lippert SolidStep Assembly

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching