Replacement Bearing Buddy Bras for Bearing Buddies with 2.13 Inch Outer Diameter

Question

Question:

my buddy bearing measures 2.13..what do i need for a bra

asked by: Joan S

0

Expert Reply:

Based on your measurement of 2.13 inches it sounds like you will need model 19B # BB19B. These have an outer diameter of approximately 2-1/8 inches. They will be easier to put on if you leave them out in the hot sun for a little while. It makes them more pliable.

The next size up would be way too big and the next size down will be too small.

expert reply by: Michael H

0

Answer 1

To determine proper fit, you will need to measure your hubs with a digital caliper like #PTW80157. You will remove the current cap and measure the inside diameter of the hub. So you would use the smaller teeth that face outward on the back of the…

view full answer...

Answer 2

That would mean that you have a Bearing Buddy designed for a 2.328 inch hub bore and you would need the part #BB2328 as a replacement.

view full answer...

Answer 3

You need to use the inner diameter of your hub bore to determine what size Bearing Buddy you need. If you measured the outside diameter and chose your Bearing Buddy on that, then it will not fit. If you measured the inner diameter, then as you said,…

view full answer...

Answer 4

Looks like you have a spline diameter of .56 inches and and threaded portion of 1/2 inch which is very popular. For that you'd want the part #K12WB2. I attached a picture that has a dimensional diagram for you to check out as well.

view full answer...

Answer 5

The portion you need to measure is not the cap, but the the hub bore. Remove the grease caps and measure the diameter of the opening the caps occupy. This is the hub bore. You will need an accurate measuring devices like a set of dial calipers that…

view full answer...

Answer 6

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...