Installation of Derale Transmission Cooler in 2013 Chevy Silverado 1500

Question

Question:

I am purchasing a Derale Series 8000 Plate-Fin Transmission Cooler Kit w/Barb Inlets - Class IV - Efficient Item # D13504 to replace my factory transmission cooler on a 2013 Chevy Silverado 1500 5.3l 6 speed auto. I’ve seen videos and instructions on how to add this product when the vehicle does not have the factory cooler. my question is when I remove the factory cooler will I need the Derale Snap-In Radiator Adapter Fitting for GM Item # D13035 or any other fittings/adapters to connect the new radiator with the supplied hose to the factory lines? Thanks

asked by: Mik B

0

Expert Reply:

It is recommended to use the # D13504 in addition to the factory cooler on your Silverado. This will further help cool the transmission fluid. If you determine you will remove and replace, then you will need the adapter fitting # D13035. My recommendation if that is the case is to use the Derale Dyno-Cool Remote Cooler with Fan and Hose Barb Inlets # D12743. This will ensure you have proper cooling to protect your transmission with the integrated fan.

Then you simply need to determine if you want to use the included tie mounts or the universal metal mount kit # D13002.

expert reply by: Jason S

0

Answer 1

All vehicles with an automatic transmission have a factory transmission cooler. Normally it is located inside the radiator but it can also be outside of the radiator. Trucks that have a tow package often have a larger cooler that is outside of the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Since the Truxedo Lo Pro you'd have installed on your 2013 Chevy Silverado 3500HD long bed would be the part #TX571601 the correct replacement tarp would be the part #TX5716-CVR.

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

You are a little on the warm side for your transmission fluid. If you can keep it under 200 degrees you will have the max life out of it. That being said transmissions really start to go downhill at 260 degrees. The Derale cooler part #D13503 with…

view full answer...

Installation of Derale Transmission Cooler in 2013 Chevy Silverado 1500

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching