Wrench Size Needed to Operate Ultra Fab Products Super Grip Chock UF21-001091

Question

Question:

What size is the wrench for the Ultra Fab Products Super Grip Chock ? Need to replace and dont want the use the same one that comes with it..

asked by: Mark

1

Helpful Expert Reply:

The Ultra-Fab Super Grip Chock Wheel Stabilizers # UF21-001091 requires a 17mm box wrench according to my contact there.

expert reply by: Adam R

1

Answer 1

There is a potential solution for you to mount your TV to allow it to swivel, but unfortunately we do not have the specs for your Forest River's current TV mount. What you may be able to do, depending on your television, is use the MORryde RV…

view full answer...

Answer 2

Yes you can use the Stromberg Carlson Base Pad Extreme for Campers and Trailers #SC88VR on a camper that is camping and not just storage.

view full answer...

Answer 3

The warranty for the Andersen Rapid Hitch Adjustable, Aluminum Ball Mount Kit #AM3405 is one year. If you purchase this item from us the warranty will be upheld by etrailer.com as well as Andersen. We are an authorized dealer for the Andersen…

view full answer...

Answer 4

With a ladder on the back of your RV it is unlikely you will still be able to fold up the 24 x 84 etrailer Cargo Carrier for RV Bumpers #e96ZR. Reason why is when the carrier folds up it takes up all the space of the bumper, so unless your bumper…

view full answer...

Answer 5

The kit you need is the part #UF21-001091. This setup is designed for wheel spacings of up to 10-1/2 inches so it would work well on yours that is 6-1/2 inches. Check out the review video I attached for more info as well.

view full answer...

Answer 6

The Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box #GY48GR will fit in place of your Lippert Turning Point pin box, yes. The pin weight range of this pin box is 1,501-3,000 lbs which should be right about in your wheelhouse - I do…

view full answer...

Answer 7

I took a look at the owner's manual for your 2017 Chevy Silverado 2500 and it said that if the "Check Trailer Wiring" message appeared you have the Integrated Trailer Brake Control (ITBC) and it indicates there is a short in the wiring…

view full answer...

Answer 8

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 11

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Wrench Size Needed to Operate Ultra Fab Products Super Grip Chock UF21-001091

Product Page this Question was Asked From

Continue Researching