Kayak Carrier Recommendation for Fitting Crossbars of Erickson Ladder Rack # EM07705

Question

Question:

Hello, Does etrailer carry J-style kayak carriers that will fit the cross bar on the Erickson ladder rack #EM07705? Thank you.

asked by: Brent S

0

Expert Reply:

We have a set of foam blocks that will fit the larger ladder rack crossbars as the Malone Foam Carrier part # MPG159 but we do not have a J-style carrier that will fit the Erickson ladder rack part # EM07705.

expert reply by: Jameson C

0

Answer 1

I reached out to Erickson and the ladder rack #EM07705 has crossbars that are 3-1/4 wide by 1-1/2 inches tall. That will make some Kayak carrier options unable to work and other still functional. The Rhino Rack Nautic Roof #RR571 and the Thule Top…

view full answer...

Answer 2

The Erickson Truck Bed Ladder Rack w/ Load Stops #EM07705 will technically fit your 2019 Nissan Frontier 5' bed, but you're going to have to remove the Utili-Track System to do so. This ladder rack uses a clamping system that uses the…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Yes, you are going to also need the Demco Autoslide Capture Plates for Trailair Rota-Flex Pin Boxes #DM6171 when using the Demco Autoslide 5th Wheel Trailer Hitch w/ Slider #DM8550040 with your Road Armor pin box. For a suspension enhancement I…

view full answer...

Answer 7

Yes, the Curt Custom Fifth Wheel Installation Kit for Ford #C93WR will work just fine with the Demco Autoslide 5th Wheel Trailer Hitch w/ Slider #DM8550040.

view full answer...

Answer 8

Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…

view full answer...

Answer 9

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 12

Thanks for reaching out, Steve! Both Air Lift LoadLifter 5000 kits, parts #AL47PD and #AL82WQ, fit a 2021 Ford F-150 4WD. The only difference is whether your truck has the CCD (Continuously Controlled Dampening)/Onboard Scales, or the PowerBoost…

view full answer...

Kayak Carrier Recommendation for Fitting Crossbars of Erickson Ladder Rack # EM07705

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching