Can Pin for Drop Leg be Moved on Pro Series Square 10,000 Pound Jack # PS1401010376

Question

Question:

Can..you..change..the..pin..from..the..side..to..front

asked by: John..matthews

0

Expert Reply:

The pin location cannot be changed but we do have Pro Series jack # PS1400950376 or # PS1400980376 which do have the pins on the front (or back depending on how you have the jack positioned).

Another option is # TJD-12000SP-F2 or # TJD2SP-12000SP-F.

expert reply by: Michael H

0

Answer 1

The entire weight of the Buyers Products Heavy-Duty 4" Square Jack w/ Side Pin Drop Leg #3370091410H is 64 lbs.

view full answer...

Answer 2

The Pro Series Square Jack #PS1401010376 has a low speed crank setup due to it's very high capacity of 10,000 lbs. But to be more specific it takes 9 cranks to move the inner leg 1 inch.

view full answer...

Answer 3

If you check out the diagram I attached of the side of the Lippert Components Spare Tire Winch #LC159056 that mounts you can see that the distance between the mounting hole locations is 5-1/4" on center. I reached out to my contact at…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 6

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 9

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...