Bolt Hole Distance for Buyers Products Black Receiver Tube

Question

Question:

What are the dimensions between the bolt holes? The one I have is 3 1/2inch on center!

asked by: Chris

0

Expert Reply:

From center to center, the bolt holes on the Buyers Products Black Receiver Tube # 3371804055 measure 3.5" vertically and 3.38" horizontally, as you can see in the accompanying photo.

expert reply by: Kyle S

0

click to enlarge

Answer 1

The Buyers Products Black Receiver Tube part #3371804055 has a vertical set of holes which are 3-1/2" apart on center and a horizonal set which are 3-3/8". I have attached a dimensions drawing from the manufacturer below.

view full answer...

Answer 2

It sounds like you're needing something like the Buyers Products #3371804055 receiver tube/mounting plate. The receiver itself is super strong, with a 20,000 lb towing/2000 lb tongue weight capacity, but the hitch will only be as strong as the…

view full answer...

Answer 3

The Buyers Products Black Receiver Tube 2" I.D. x 6" Long Welded To 1/2" Mounting Plate #3371804055 measures 3-1/2 inches to the plate from the center of the hitch pin hole, however the plate has a cutout where the receiver tube is, so…

view full answer...

Answer 4

There is an adapter that will allow you to use the Furrion back-up camera on your 2021 Chevy Silverado, and no waiting list is needed, it is available with this part: - 7-Way Vehicle Power Adapter w/ Power Switch for Furrion RV Observation Camera…

view full answer...

Answer 5

Trailer wheel lug nuts that are 1/2-inch inside diameter typically have a 20-TPI thread pitch (20 threads per inch). Most lug nuts also use a 60-degree-coned profile like #CE11051, but a 90-degree like #STN569 is also available for 9/16-inch studs.…

view full answer...

Answer 6

I spoke to my contact at Curt and he informed me that from the center of the mounting holes that are on the mounting bracket on top of the hitch opening to the end of the opening measures 1-1/2 inches.

view full answer...

Answer 7

If you were to get the Curt Class IV Hitch Receiver #C14029 it may fit your 1996 GMC Yukon with a roll pan but to be sure, here are some measurements. From the mounting plates to hitch receiver top (height) it's 2-1/2 inches and from the bottom…

view full answer...

Answer 8

The distance between the bolt holes on the Curt Trailer Hitch Receiver #14080 is 39-1/4" center-to-center. I have attached a photo to demonstrate this. Please note that this trailer hitch fits the following: 2002 - 2002 Chevrolet Avalanche 2002…

view full answer...

Answer 9

I have a solution for you but the Buyers Products Hitch Plate for Pintle Mounting item #3371809030B only fits 1999 and newer Ford F-350's. For your 1986 F-350 Cab and Chassis you will want the Buyers Products Flatbed/Flatbed Dump Hitch Plate…

view full answer...

Answer 10

Are you looking at the Blue Ox SwayPro weight distribution shanks, like part #BXW4002? If so, Blue Ox does not give these shanks a specific class rating. All of their shanks fit 2 inch trailer hitches and have a maximum towing capacity of 15,000 lbs…

view full answer...

Bolt Hole Distance for Buyers Products Black Receiver Tube

Product Page this Question was Asked From

Continue Researching