Can Reese Towpower ATV Hitch be Used in the Drop Position

Question

Question:

What is the Metal thickness for the Reese Towpower 3-Way ATV Hitch #RP7065000? Also, I need to mount this hitch in the drop position. will the d-ring be in the way of the ball?Would I still be able to use the ball mounting the hitch in the drop position? THANK YOU

asked by: Patrick L

0

Expert Reply:

The Reese Towpower ATV Hitch, part # RP7065000, measures 3/8 of an inch thick except for the D-ring. The D-ring is a 1/2 inch thick.

The hitch can be used in the dop position. I went out and looked at it and there's plenty of room for a hitch ball to not interfere with the D-ring.

expert reply by: Charles S

0

click to enlarge

Answer 1

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures…

view full answer...

Answer 2

The dimensions of the Replacement Upright for CE Smith Bunk-Style Guide-Ons #CE27605PG are 39 inches tall by 23 inches long. The tube is 1-1/2 inches and the bend is a 90 degree angle. I've attached a picture for you as well.

view full answer...

Answer 3

Thanks for the picture! You're going to need the Equal-i-zer #EQ90-02-4200 which will replace your existing shank, and give your at least 2 more inches of drop which should get you just about perfectly level.

view full answer...

Answer 4

The Reese Towpower 3-Way ATV Hitch #RP7065000 measures 2" at two of the holes and then 2-5/8" at the middle one. I've attached a photo for you to reference.

view full answer...

Answer 5

The 18 inch long Equal-i-zer weight distribution shank part #EQ90-02-4600 does give most trucks and trailers the ability to tow with the tailgate down like it sounds like you are planning on doing and like what you see in the attached picture. Now…

view full answer...

Answer 6

For your Brake Buddy, the power should come from your vehicle battery to prevent a loss of power to your braking system. However, if you utilize the 12V power at your 7-way and use the Roadmaster Battery Charge Line Kit for Towed Vehicles #RM-156-25…

view full answer...

Answer 7

The diode #RM-690 can handle up to 120 volts at 24 amps so it should work just fine for your needs provided nothing else exceeds 120 volts at 24 amps. Regarding your picture, most battery chargers or batteries on vehicles say not to ground the…

view full answer...

Answer 8

I do have a better option for you but the Tekonsha Two Stage 12 V DC Battery Charger part #2024-07 is mainly used to charge a breakaway systems battery which is much smaller than the 12 volt battery you have on your toad. A better option for you…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Can Reese Towpower ATV Hitch be Used in the Drop Position

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching