Will Lippert RV Landing Gear Foot Pad # LC314667 Fit an Alpha See YA Class A RV

Question

Question:

Im replacing a lost Jack pad for my ALPHA See YA Class A RV... will your part LC314667 work for my application?

asked by: William D

0

Expert Reply:

Lippert Components 5th Wheel RV Landing Gear Foot Pad # LC314667 takes a 7/16 inch bolt. In order for it to fit your jack leg the bolt size would need to be the same. You can also check for any part numbers on your jack system and I can check if there is an exact replacement for it.

expert reply by: Michael H

0

Answer 1

It can indeed be used if the jack leg can accommodate the 1-1/4 inch width beetween the mount ears as shown in the provided photo. If the leg is too wide to fit in between the ears, they might fit inside the leg is the inside of the leg is greater…

view full answer...

Answer 2

For your Lippert Level Up Hydraulic Leveling System, you can use the: -Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System #LC324269. These replacement feet are 9" in diameter, and also includes the o-rings, the bolt, and…

view full answer...

Answer 3

Replacement foot pad #LC314667 isn't the exact replacement for your Level Up system. The one for the Level Up is not available as a replacement. But you could use #LC314667. The issue is that it uses a smaller bolt than the Level Up foot. So you…

view full answer...

Answer 4

The Lippert Components 5th Wheel RV Landing Gear Foot Pad - 9" Round #LC314667 is the original part for the Ground Control 2.0 system like you mentioned, but the Replacement Front Foot Pad for Lippert Components Ground Control 3.0 Leveling…

view full answer...

Answer 5

The Lippert Components 5th Wheel RV Landing Gear Foot Pad - 9" Round #LC314667 is compatible with your landing gear leg. The Replacement Front Foot Pad for Lippert Components Ground Control 3.0 Leveling System #LC362486 will work for your system…

view full answer...

Answer 6

The Lippert Components 5th Wheel RV Landing Gear Foot Pad - 9" Round #LC314667 is the original part for the Ground Control 2.0 system, but the Replacement Front Foot Pad for Lippert Components Ground Control 3.0 Leveling System #LC362486 will…

view full answer...

Answer 7

Lippert does not make the specific foot pad for the Level Up system a replacement part, so the best option for a replacement is the Lippert Components 5th Wheel RV Landing Gear Foot Pad #LC314667. Please keep in mind this may require you to source a…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

I went ahead and pulled this Replacement I-Beam Jack Bracket #LC349975 from our warehouse to measure. I have attached the dimensions below. Hope this Helps.

view full answer...

Answer 12

The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts - 0.20-Fl-Oz Tube…

view full answer...

Will Lippert RV Landing Gear Foot Pad # LC314667 Fit an Alpha See YA Class A RV

Product Page this Question was Asked From

Continue Researching