What Size Bolts are Used to Install Trailer Hitch 75663 on a 2010 Toyota Venza
Question:
Hi, wath is the bolt size and tread for a toyota venza 2010 with a draw rite hitch 2
asked by: Luc
Expert Reply:
Draw-Tite trailer hitch # 75663 for the 2010 Toyota Venza uses M10-1.25 x 40mm CL 10.9 Hex Bolts, 3/8” Conical toothed Washers, and 5/16” x 1” x 1-1/2” Block-Spacer, ( AWD vehicles only).
If you have the hitch but not the hardware order # RHK. Enter the hitch number and manufacturer on that page to get the right hardware.
If you have the hardware but it is not going in easily then the weldnuts will need to be cleaned. I have included some links that show and explain this for you.
Products Referenced in This Question
Replacement Hardware Kit for Trailer Hitches
- Accessories and Parts
- Trailer Hitch
- Hardware
- etrailer
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Recommended Trailer Hitch Receiver for a 2010 Toyota Venza with Dual Exhaust
- Q&A: Vehicle Sag To Carrier About 3 Inches Off The Ground In 2010 Toyota Venza
- Q&A: Front Mount Trailer Hitch For 2024 Ram 2500
- Q&A: Availability Of Front Hitch For 2022 Ram 3500 Diesel
- Q&A: Are The DeeMaxx Hub/Rotor Assemblies Compatible With Kodiak 225 Calipers?
- Q&A: Can Trailer Hitch be Installed on 2015 Toyota Venza With AWD All-Wheel Drive
- Q&A: Using the Yakima LongArm as a Load Assist Just Like the Rhino-Rack T-Load
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Choose the Right Trailer Hitch Class
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch