Troubleshooting AirLIft Wireless Controller with Error Message  

Powder coating and galvanization are both about the same in terms of rust resistance. If you like the black of the part #e42VR it would work just as well as a galvanized version #e62VR.

Yes, the B and W Continuum part #BW78FR will prevent the porpoising you are experiencing. It allows you to fine tune the spring bar tension a lot more than the Andersen setup you have now so it will provide a much better towing experience. The…

Yes, you can use the B and W Continuum #BW78FR an Air Lift air bag kit #AL88375 on your 2020 Ram 1500. You would want to first decide how much air pressure in the bags you want and then setup up the Continuum and you'd be set.

I don't think the Shocker Air Equalizer for Weight Distribution Hitch part #SHK68VR would be compatible with the B&W Continuum Weight Distribution System part #BW78FR due to a few reasons, clearance being one but this is also not…

To be completely honest the sway control feature of the B and W Continuum part #BW78FR isn't nearly as advanced as the rest of the system. The advertised sway control of this system is in the head of the system between where the ball and the…

Yes. The etrailer Horizontal E-Track - Galvanized Steel - 2,000 lbs - 8' Long #e62VR can be driven on without any issue and have a maximum capacity of up to 6000-lbs each(break strength), so they'll be able to handle your ATV/UTV without…

The Air Lift Wireless AIR Compressor System #AL74000 will show an error whenever there is any type of issue with the system. Generally this is an issue with the remote communicating with the system, a blockage, or a leak. I would inspect the…

The A14 error code on Air Lift compressor kits like the WirelessAIR part #AL74000 that you referenced indicates you have a bad ground on the compressors wiring. You'd want to basically go over the wiring of the kit but look specifically at the…

The lip is supposed to be there. It appears to be a way to allow the bracket to set more level than what the frame of the truck allows since it is angled and not parallel to the ground.

According to Air Lift, there are a few things that can cause this issue. The problem is likely an air leak between the manifold and the compressor or simply a weak compressor that would need to be replaced. To get the compressor running again so you…

Start off by double checking that you have everything installed correctly and that you have installed two CR2032 batteries in your Remote for Air Lift WirelessONE Compressor Systems #AL72704. If you check out the attached clip from the instructions…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…