Recommended Ball Mount Without Hitch Ball for Trailer Hitch Receiver

Question

Question:

Am looking for a ball mount without a ball. Do you sell them? I need a short ball mount, about a 2 inch . thank You

asked by: Dan C

0

Expert Reply:

We have over 100 options of ball mounts without a hitch ball. The short ball mount is where the issue may come in. I assume you want one that is 2 inches from the receiver opening collar and we don't have that specific measurement as different manufacturers have different collars on their hitches and each one is vehicle specific fit. I recommend the Curt Ball Mount for 2" Hitches # C45030 for a 2 inch receiver or # C45518 for a 1-1/4 inch receiver.

I've linked the page to all of your options. We measure from the center of the hitch pin hole to the center of the hitch ball hole for you to compare between options. I've also attached a rise or drop article to assist.

expert reply by: Jason S

0

click to enlarge

Answer 1

We offer weld-on and bolt-on trailer jacks that are similar to the Shelby 5764A jack you wish to replace but the jacks we offer are not exact replacements. We do have a jack that has a mounting plate similar to the Shelby mounting plate., It is part…

view full answer...

Answer 2

Swapping the mounting hardware on a jack can be done, but it will depend on the specific mounting hardware of the jacks. Shelby jacks and parts are becoming more difficult to locate, so I would recommend replacing your Shelby hardware with something…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, we do! To add a hitch to your 2024 Honda Pilot, I recommend the etrailer item #e27KR. This hitch is custom fit and bolts to your Honda with included hardware. This is a class III hitch with a 2" receiver that has a 6,000 lbs towing capacity…

view full answer...

Answer 5

Yes, the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C48ZV is indeed a Curt part. We do not have a video at this time.

view full answer...

Answer 6

Since your 2024 Telluride X-Line is not an LS or S model the correct wiring harness is the Curt #C29ZV. This will plug into the connection points in the rear cargo area and provide you with a 4-way to power your trailer's signal lights. The…

view full answer...

Answer 7

If your 2020 Kia Sorento has the factory tow package, there will be a tail light wiring connector behind the rear tire of the driver side, on the outside of the frame rail. As shown in the attached photos, an underbody cover will need to be removed…

view full answer...

Answer 8

For your 1993 Ford E350 Van the only style of trailer wiring we have is the kind that installs inline with the vehicle taillights like the T-One kit part #118343. With this kit you'd unplug your vehicle taillight connectors and plug this kit…

view full answer...

Answer 9

You will need a 19 mm socket to install the etrailer Hitch item #e23ZR. The instructions call for a 17mm as well but none of our installation videos use one. The passenger side is a tight fit so I recommend using a box wrench or a ratcheting one. I…

view full answer...