Could Dexter Heavy-Duty Suspension Kit # K71-449-00 be Used on Triple Axle Trailer

Question

Question:

Concerning the double axle hanger kit K71-449-00 can i use two of these together for a three axle set up? Thanks

asked by: Mike F

0

Expert Reply:

Yes, you could use a second set of the Dexter Heavy-Duty Suspension Kit # K71-449-00 and you'd be set for a triple axle trailer.

expert reply by: Jameson C

0

Answer 1

Yes the Dexter E-Z Flex Suspension Kit #K71-657-00 definitely is a fit for your trailer based on the axle spacing and the shackle dimensions you listed.

view full answer...

Answer 2

The Dexter Heavy Duty Suspension Kit part #K71-360-00 has bronze bushings and wet bolts whereas the Triple-Axle Trailer Hanger Kit part #APTT3 has nylon bushings and standard bolts. The bronze bushing resist wear more than nylon and the wet bolts…

view full answer...

Answer 3

It sounds like the Replacement Shackle Link with Bolts #018-026-05 that you referenced is what you are needing. It comes with the shackle and wet bolts that have a grease zerk fitting installed on them. This kit is compatible with the following heavy…

view full answer...

Answer 4

The E-Z Flex Triple Axle Suspension Kit part #K71-657-00 comes with both flange nuts part #006-092-01 and lock nuts part #006-007-01. The flange nuts which are essentially a nut that has an integrated washer that reduces the chance of loosening…

view full answer...

Answer 5

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 6

To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of the…

view full answer...

Answer 7

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…

view full answer...

Answer 10

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 11

Yes, axle spread and wheel base by definition are the same measurements. You will measure from the center of one axle to the center of the 2nd axle to determine what you axle spread is. This may be difficult as some wheels and covers will make this…

view full answer...

Answer 12

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

view full answer...

Could Dexter Heavy-Duty Suspension Kit # K71-449-00 be Used on Triple Axle Trailer

Product Page this Question was Asked From

Continue Researching