Replacement Anode Rod Recommendation for Suburban Mor-Flow Water Heater

Question

Question:

I need anode rod for a Casita trailer 6 gal. Rv hot water heater. Made by Suburban. Model # SW6DE. The rod is about 9 1/2. Do you carry one like it. Thx

asked by: Lowell B

0

Expert Reply:

We have just what you need. The replacement anode part # CAM11563 is the exact replacement you need for your Suburban Mor-Flow heater. This is 9-1/2 inches long and has a diameter of 3/4 inches.

expert reply by: Jameson C

0

Answer 1

Can you get me the diameter, length and brand of water heater you have? With that I can determine what anode rod you'd need. For example the Camco anode part #CAM11563 fits Suburban Mor-Flo heaters that have a 3/4" diameter and 9-1/2"…

view full answer...

Answer 2

The Camco RV Water Heater Anode Rod #CAM11563 is the anode rod we carry for Suburban water heaters. This is made of aluminum and measures 3/4 of an inch in diameter and 9-1/2 inches long. You'll need to make sure it's a match with yours.

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 5

There is a Titan hitch extender that should work for you, but would require a Titan hitch be installed on your truck to handle a tongue weight loaded that far from the hitch. It is Reese part #RP45292. You can use it as a 34 inch extension or cut it…

view full answer...

Answer 6

You can use a 7-Way and 4-Way connector at the same time just as long as you are not overloading the light circuits. If your camper has a lot of outside lights like running lights, and brake/stop/turn lights then the lights that perform the same…

view full answer...

Answer 7

The Reese Titan Extension/Reducer you referenced, part #RP45292 would work great with the 2-1/2 inch Class V hitch on your Ram. As you mentioned, the extension has a 8K capacity when cut down to the 24 inch length, that will provide a 2 inch receiver…

view full answer...

Answer 8

We have a full replacement for your light. The Command Electronics #CE86FR. Take a look at the attached video to see them in action.

view full answer...

Answer 9

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 10

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Replacement Anode Rod Recommendation for Suburban Mor-Flow Water Heater

Product Page this Question was Asked From

Continue Researching