Replacement Puck Trim Rings for 2014 Ram 2500 with Factory 5th Wheel Prep Package

Question

Question:

do you sell the puck trim rings? for the pucks # 58199?

asked by: Eaan C

0

Expert Reply:

I checked with Reese who makes the factory under bed 5th wheel system for the 2014 Ram 2500. For replacement puck trim rings you will need # RP58458.

expert reply by: Michael H

0

Answer 1

As long as you cut the BedRug in your truck so that the B&W Companion 5th Wheel Hitch #BWRVK3500 makes complete contact with the bed you can absolutely do this. As you mentioned you will just need to trim around the base/pads of the Companion and…

view full answer...

Answer 2

There are 2 sets of holes on the Reese adapter #RP30154 for Rams with the OEM prep package. The outside set of holes is 29 inches apart on center and the inner set is 20-1/2 inches apart on center. Front to back they are approximately 22 inches apart…

view full answer...

Answer 3

You will have no problems using the B&W Companion OEM 5th-Wheel Hitch for Ford Super Duty Prep Package part #BWRVK3300 in the bed of your truck with a rubber bed mat installed. You will just need to trim the holes where the feet of the B&W…

view full answer...

Answer 4

To answer your initial question, the base is 22" square, so the measurement from the ball center to the back edge nearest the cab is 11-1/2 inches. Additional, the flat metal at the back of the hitch nearest the cab is 2-3/4 inches wide. I have…

view full answer...

Answer 5

There is definitely a way to tow a 5th wheel trailer with your 2021 Ram that is equipped with the RamBox, but it's going to require some new components both on the trailer and your truck. The issue with the Ram Boxes is that they make the bed…

view full answer...

Answer 6

You are correct that the Ranch Hitch #AM3100 adapter is not compatible with the Tri-Glide pin box as it was designed to be used with standard pin boxes only (nothing cushioned or with an air bag). It is important to have some cushion in weight…

view full answer...

Answer 7

The Demco Recon Gooseneck-to-5th Wheel Trailer Hitch Adapter #DM8550045 referenced in your question uses a coupler at the base to securely attach to a standard 2-5/16 inch diameter gooseneck ball. Top and side coupler bolts hold it in place so that…

view full answer...

Answer 8

When you are using the Demco Recon Gooseneck-to-5th Wheel Trailer Hitch Adapter #DM8550045 you will either need to remove your bed liner or cut out your bedliner where the base of the adapter sits (unless it is a spary bed liner). My contact at Demco…

view full answer...

Answer 9

For the center gooseneck hitch ball location of your Ram factory rail kit you will need part #RP30136 and for the safety chain or forward 5th wheel hitch locations you will need the Replacement Puck Plug Covers #58199. These aren't going to fit…

view full answer...

Answer 10

The base of the Demco Recon Gooseneck-to-5th Wheel Trailer Hitch Adapter #DM8550045 needs to sit directly on the truck bed, which means you do have to cut the bed liner on your truck for the Recon to properly secure. If you check out the accompanying…

view full answer...

Answer 11

Yes. You will either need to remove or cut out the space that your B&W Companion Hitch #BWRVK3300 sits in so that it can have complete contact with the truck bed surface; you could also switch to a spray in liner if you wanted to make sure you…

view full answer...

Answer 12

We do carry a set of trim rings for the Reese Elite Series 5th Wheel Rail Kit, #RP58458, but these trim rings are not confirmed to fit the Ram prep package on your 3500 truck. I went out to our warehouse and took some measurements of the Reese trim…

view full answer...

Replacement Puck Trim Rings for 2014 Ram 2500 with Factory 5th Wheel Prep Package

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching