What are the Dimensions of the T-bolt Slot on a Malone Aero Crossbar

Question

Question:

What are the dimensions of the T-bolt slot on these crossbars?

asked by: Ben

0

Expert Reply:

I measured one of our Malone Aero crossbars like part # MPG216 and found the T-bolt slot to measure 1/4" x 13/16" with the top opening measuring 7/16".

This is a pretty standard size T-bolt slot and should be able to accommodate any of your roof rack accessories.

expert reply by: Jon G

0

Answer 1

Malone AirFlow roof racks like #MPG215 can use their own T-Slot Fit Kit #MPG8287 for Malone carriers or you can use another T-bolt fastener. I linked a photo showing a cross section of the AirFlow bar and the exact inside dimensions. I converted the…

view full answer...

Answer 2

The manufacturer does not call out a specific size t-bolt that must be used with the Malone AirFlow2 Roof Rack part #MPG216. This information would do you no good anyhow as roof rack accessories don't call out the size of the t-bolt used in their…

view full answer...

Answer 3

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 4

For your 2015 Ford F-250 I recommend going with the longer Rhino-Rack Roof Rack System #Y02-500B that includes 65 inch crossbars. These bars will reach across the width of your Ford's bed and also provide just a bit of overhang to better…

view full answer...

Answer 5

I was able to go to our test fit bays and use a digital dial caliper to measure the top channel on the Rhino Rack Vortex Aero Crossbars #RRVA126B-2, that with the SX Series Legs #RRSX100 are confirmed to fit your 2015 Toyota Sienna with factory…

view full answer...

Answer 6

You'll be able to use almost any replacement strip as they are almost always fit for a 3/8 inch channel. I specifically recommend the Thule Replacement Channel Cover 59 inch, part #852-5402-005 or the Rhino Rack Vortex 15-3/4, part #RRM626. These…

view full answer...

Answer 7

The width of the C channel that connects the 54 inch Rhino-Rack Vortex Crossbar to the foot is 1 inch and the width of the opening is 1/2 inch. The depth of the channel is 5/8 inch.

view full answer...

Answer 8

We do have the rubber strips for both the top and bottom of the Malone AirFlow2 crossbars. There are 3 different size bars with a top and bottom strip for each listed below. 50" Malone AirFlow2 Roof Rack #MPG215 Top Strip #MAL63TR Bottom Strip…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

What are the Dimensions of the T-bolt Slot on a Malone Aero Crossbar

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching