Roof Vent Install Kit Recommendation for RV with Fiberglass Roof

Question

Question:

Just checking to make sure it will stick to clean fiberglass or should I use something else to install a vent on a fiberglass trailer

asked by: Carl R

0

Expert Reply:

Since you have a fiberglass roof the RV roof vent install kit you'd want is the part # 344270KITW. The Butyl tape kit you mentioned # CAM25013 is for use with rubber roofs or sidewalls so it would not work for you.

expert reply by: Jameson C

0

Answer 1

The vents we offer for an enclosed trailer like part #9139 are designed to allow air into the trailer. None of the vents we offer create a pressurized condition in the trailer and none are equipped with an air filtration system to keep dust out. Some…

view full answer...

Answer 2

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...

Answer 3

Great question but the current MaxxFan roof vents like part #MA00-06401K can be used with lithium batteries. There was an issue with the older models of the MaxxFans but they went to a different circuit board that can handle the higher voltage for…

view full answer...

Answer 4

There is not a specific size of tape you will need to install a MaxxAir MaxxFan. I recommend using the RV Vent Installation Kit part #CAM25013 which comes with 8' long x 3/4" wide of white butyl tape that should be more than enough for your…

view full answer...

Answer 5

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 6

The Solera 14' Slider (Slide-Topper) in White w/ White Hardware #LCV000163301 comes with everything you need for installation except the #CAM25013 which is an 8 foot length that is shown in the video as you stated. I do recommend getting two of…

view full answer...

Answer 7

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 8

The Hengs 311 is a white silicone based self leveling sealant. For a white self leveling sealant the part #AL98KV would be a really great replacement.

view full answer...

Answer 9

While we have heard of people using electrical vents like the MaxxFan Roof Vent w/ 12V Fan #MA00-07000K above a tub/shower, it is not meant to be installed in that location because water from the shower and steam can potentially affect the…

view full answer...

Roof Vent Install Kit Recommendation for RV with Fiberglass Roof

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching