What Reese Weight Distribution System is Compatible with Dual Cam Sway Control

Question

Question:

Can you use this with a trunnions weight distribution system.

asked by: Mark H

0

Expert Reply:

If the trunnion weight distribution system has spring bars with curved ends like the Reese system part # RP66542 has then yes you can use the part # RP26002 with it.

I attached a picture of what the spring bar ends need to look like.

expert reply by: Jameson C

0

click to enlarge

Answer 1

There is a simple solution for you to use your Curt TruTrack #C17501 on a trailer frame that is 8 inches. What you would need to do is use the Frame Brackets for 8" Frames #C17515, which is designed to work with your system and clamps onto…

view full answer...

Answer 2

The best way to pick out a weight distribution system is to based on the loaded tongue weight of your setup when it is fully loaded and ready to go. I would recommend loading your trailer up camper like you are going on a trip and then determining…

view full answer...

Answer 3

Here's the story about backing your trailer with a weight distribution system. If you're using a friction sway control like part #83660, you should remove the sway control unless you're backing more or less in a straight line. If…

view full answer...

Answer 4

You can have a 2-5/16 inch hitch ball on either a 1 inch or 1-1/4 inch shank. The nut on a hitch ball with a 1-1/4 inch shank takes a wrench with a 1-7/8 inch socket. A hitch ball with a 1 inch shank will take a wrench with a 1-1/2 inch socket. You…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

What Reese Weight Distribution System is Compatible with Dual Cam Sway Control

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching