Will Hopkins Plug-In Simple Wiring Harness # HM11141845 Fit 2016 Toyota Highlander

Question

Question:

Have a 2016 Highlander pretty sure no tow package is this the right harness?

asked by: Shawn

0

Expert Reply:

Yes, the Hopkins Plug-In Simple Vehicle Wiring Harness # HM11141845 referenced in your question is confirmed to fit your 2016 Toyota Highlander that does not have the factory tow package. This custom-fit harness will install by connecting directly to the built-in ports located in the rear cargo area on the driver's side of your vehicle. This will provide you with a 4-Way connector that will connect with and power a trailer's basic signal lights.

I have attached an installation video on your 2016 Highlander that you can use for reference.

expert reply by: Chris R

0

Answer 1

I'm happy to help you get what you need for towing. I did a little research to find your 2017 Toyota Highlander SLE AWD towing capacity to be 5,000 lbs. Based on that, you will not have an issue with a 3,850 lb travel trailer with 400 lb tongue…

view full answer...

Answer 2

This Hopkins wiring harness does fit your 2019 Toyota Highlander. Since the location of the factory wiring is located inside the car and not under/behind the bumper, you will likely be limited to the current location of the wiring. That being said,…

view full answer...

Answer 3

If your vehicle has a functional factory tow package there will be a connector at the rear of the vehicle behind the rear bumper. You may have to remove the trim panels to find it. I have made a diagram of the areas you should check for the OEM…

view full answer...

Answer 4

The Curt trailer wiring harness #C56217 and other wiring harnesses for your 2014 Toyota Highlander include converter boxes because the vehicle has separate turn signals and brake lights but trailers have combined turn signals and brake lights. The…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Will Hopkins Plug-In Simple Wiring Harness # HM11141845 Fit 2016 Toyota Highlander

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching