CE Smith Post-Style Guide-Ons # 27620 Hardware Compatibility with Boat Trailer Frame Styles

Question

Question:

do different size of U bolts come with it for different trailer frames? channel, box, tube etc ?

asked by: Dale E

0

Expert Reply:

The CE Smith Post-Style Guide-Ons for Boat Trailers # CE27620 come only with the one style of U-bolts but the installation instructions I've attached show how these work with box frame, C-channel, or I-beam frames. The only frames that would require different hardware would be a round tube frame.

expert reply by: Jason S

0

Answer 1

Good news! The CE Smith Guide-On Posts #CE27620 will fit your rails, as long as your frame members aren't wider than 3-3/4 inches wide and 4-1/4 inches tall. For your 1-1/4 x 2-1/2 inch frame you would just need to tighten down the u-bolts and…

view full answer...

Answer 2

The guide posts will fit, as long as your frame members aren't wider than 3-3/4 inches wide and 4-1/4 inches tall. They are adjustable up to 13-inches from the outside edge of the trailer frame. (See picture to the right). The guide posts extend…

view full answer...

Answer 3

The 40 inches of the CE Smith Guide Ons part #CE27620 is the dimension of just the PVC pipes. The height of the metal brackets that the pipes slide on are 21 inches.

view full answer...

Answer 4

According to the instructions for the CE Smith Post-Style Guide-Ons part #CE27620, the upright posts will need to be positioned less than 1" from the boat's widest point. Since your boat is wider in the middle than at the end, the posts will…

view full answer...

Answer 5

We have the CE Smith Post-Style Guide-Ons #CE27620 which are 40 inches tall like it sounds like you need. These can attach to boat frames that are up to 3 inches wide and 4-1/4 inches tall.

view full answer...

Answer 6

The PVC pipes included with the CE Smith Post-Style Guide-On #CE27620 measure 40-inches. These 2-inch diameter pipes can be cut to size if required, or replaced with locally-sourced pipes of the length you prefer. I have no confirmation that this…

view full answer...

Answer 7

Post-Style Guide-Ons for Boat Trailers, like #CE27646 are designed to help you load your boat onto your trailer. Because the rear of the trailer is backed into the water, it makes it really hard to see if you're loading it straight onto the…

view full answer...

Answer 8

The CE Smith Post-Style Guide-Ons for Boat Trailers - 40" Tall #CE27620 are adjustable and it is recommended to mount the posts as close to the rear corners as possible and adjust the posts so that the distance between each post and your boat is…

view full answer...

Answer 9

The CE Smith Post-Style Guide-Ons for Boat Trailers part #CE27620 would work on a Prestige Boat Trailer with some slightly modifications. For starters, they will need to be mounted on top of the frame and then you'd need to drill into the diamond…

view full answer...

Answer 10

That's a good question, and yes, the U-bolts will fit your 3" x 1-1/4" channel frame for the CE Smith guide-ons you asked about, which are the following part number: - CE Smith Post-Style Guide-Ons for Boat Trailers #CE27620 I have…

view full answer...

Answer 11

I took the picture you sent in and put the dimensions you are looking for on them. I attached the dimensions to this page for you to check out as well.

view full answer...

Answer 12

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

CE Smith Post-Style Guide-Ons # 27620 Hardware Compatibility with Boat Trailer Frame Styles

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching