Parts Needed to Install Advent Air Rooftop RV Air Conditioner # ACM135 in RV

Question

Question:

Does the acm135 include inside assembly and if not which one do I need

asked by: Tom

0

Expert Reply:

With the Advent Air Rooftop RV Air Conditioner # ACM135 that you referenced you will need to also get the interior vent setup part # ACDB which comes with a thermostat as well.

expert reply by: Jameson C

0

Answer 1

The rooftop condenser unit will have a tag on it under the shroud which will give you the model/serial numbers of the system. If you're looking to replace just the rooftop unit and still keep your air distribution box and thermostat then I…

view full answer...

Answer 2

The Carrier Air V RV Air Conditioner is no longer produced so a direct replacement of the same unit is not an option. However, we do have available the two Advent AC models that are designed as replacement units for the Carrier Air V. I recommend…

view full answer...

Answer 3

The startup capacitor is not already installed on the AC. To install the start capacitor, you will need to bolt it to the fan motor support with the included hardware. Next you will need to route the wires to the run capacitor. Once installed the…

view full answer...

Answer 4

There are two air distribution boxes for the Advent Air conditioners that we offer. Both have thermostats however, one is a wall mounted and the other is built in. I recommend the Air Distribution Box Item #ACDB which has a built in thermostat and…

view full answer...

Answer 5

The Advent #ACM135 is a roof top air conditioner unit that puts out 13,500 BTU of air conditioning power. This is the roof top portion only. You will also need the Advent #ACDB inside air distribution box with built in thermostat. Together this would…

view full answer...

Answer 6

The Advent Air RV Air Conditioner - 15,000 Btu - White #ACM150 is designed to just replace the outside part of the AC system and utilize the old system components like the air distribution box, ducts, and thermostat. It is directly compatible with…

view full answer...

Answer 7

Correct, the Carrier Adapter Wiring Kit for Advent Air RV Air Conditioners part #ACCARKIT will not work with Carrier Air V RV Air Conditioner if it has the heat pump. Since you do have the heat pump you will need to replace the distribution box as…

view full answer...

Answer 8

There is not a standard plug available that would allow you to plug the Advent Air Rooftop RV Air Conditioner #ACM135 right to an extension cord. The unit will need to be hardwired using the included wiring and hardware. I have attached the complete…

view full answer...

Answer 9

The best choice for replacing your Carrier RV Air Conditioner is the Advent Air Replacement RV Air Conditioner for Carrier Setup, #ACCAR150 for 13,500 Btu's or #ACCAR135 for 15,000 Btu's. This AC unit replaces the Carrier air conditioner on…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...