Block Heater Recommendation for 2008 Ford Ranger with 3.0 liter V6

Question

Question:

Which models are compatible with a Ford vulcan 3.0l v6 found in the 2008 Ranger? Thank you!

asked by: Mark

0

Expert Reply:

For your 2008 Ford Ranger with a 3.0 liter V6 we have the Kat's block heater part # KH11409 which is a confirmed fit.

It installs in the plug on the passenger side of the engine closest to the front of the truck.

expert reply by: Jameson C

0

Answer 1

For a smaller, single axle travel trailer, the #NCTP1002 iN-Command system would work perfectly. The kit provides 2 sensors and would use your smart phone as the control module. The #NCTP100 provide a repeater and 4 sensors, and would be a better…

view full answer...

Answer 2

Kat's Heaters Lower Radiator Hose Heater w/ 270 F Thermostat part #KH16500 is a universal fit that will work well for your 2010 Nissan Sentra as long as your radiator hose is 1-1/4" in diameter. The Kat's Lower Radiator Hose Heaters are…

view full answer...

Answer 3

I checked with Kat's and they don't show the lower radiator hose heater option for a 2019 Ram 1500 with 5.7. They instead recommend using the Kat's Heaters Custom Fit Engine Block Heater part #KH11816

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Block Heater Recommendation for 2008 Ford Ranger with 3.0 liter V6

Product Page this Question was Asked From

Continue Researching