Axle U-Bolt Recommendation for Kaufman Trailer with 10k Axles

Question

Question:

Item: 091148 Hi I need the u bolt for a kaufman trailer for 10,000 pound axel. Is this the correct part? Thanks

asked by: Nazbi

1

Helpful Expert Reply:

Most 10k trailer axles are 5 inches in diameter which is what the part # 091148 is designed to fit. I'd be surprised if this did not work for you but I would still recommend you measure the diameter of your axle to be sure.

expert reply by: Jameson C

1

Answer 1

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 2

The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…

view full answer...

Answer 3

The two springs on a Reese 16K 5th wheel trailer hitch require access to the inner workings of the hitch. One spring is associated with the handle and one end goes to the handle and the other end hooks onto a point near the front of the hitch head.…

view full answer...

Answer 4

The Dexter Hub #8-288-3UC1 has 5/8" wheel bolts. For 5/8 inch lug nuts torque them to 175 - 225 foot pounds.

view full answer...

Answer 5

We do have a disc brake kit that is compatible with the Dexter Axle Oil Hub for 9,000-lb - 10,000-lb General Duty Axles #008-430-03 and for Dexter general-duty axles manufactured after May 2013. This disc brake kit is for spring axles only (which…

view full answer...

Answer 6

I went to our warehouse and measured one of the part #C16902 pins for you. I have attached a photo that has the dimension you were asking about. As the photo denotes, the useable length on the pin is 3.56 inches. You might want to measure the pin you…

view full answer...

Answer 7

The Kodiak 10K Disc Brake Kit #K2R1058D11 is intended to allow conversion of a Dexter 8-288 idler hub for use with disc brakes. It is compatible ONLY with one specific hub, the Dexter hub 8-288 built between February 1990 and August 2009. What you…

view full answer...

Answer 8

Actually on brake magnets for trailers either wire can be used as the power or the ground so the colors don't really mean anything. Most likely the magnet manufacturer just put what ever color was most convenient on your trailer.

view full answer...

Axle U-Bolt Recommendation for Kaufman Trailer with 10k Axles

Product Page this Question was Asked From

Continue Researching