Timbren Suspension Recommendation for 1995 Ford F-350 with Camper

Question

Question:

Trying to improve the support in the rear of my F350, was thinking about installing some Timbren suspension system. Thought about going the airbags route, but given that my camper sits on top of the truck most of the time, decided Timbren would be a simpler solution. Would you recommend going with the standard fr350sde or heavy duty frtt350e version for my setup? Thanks!

asked by: Cayetano G

0

Expert Reply:

Thanks for the picture of your truck. That's quite the camper! If I were you I would go with the higher rated Timbrens part # TFR350SDE which is a confirmed fit for your 1995 Ford F-350 as your camper looks like it weighs quite a bit and the extra capacity will help you quite a bit.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Timbren Rear Suspension Enhancement System part #TFRTT350E is exactly what you will want to use on your 2002 Ford F-250 to haul your in-bed camper as they are designed for exactly this purpose and will take a lot of the sway out due to the higher…

view full answer...

Answer 2

Yes, you can fit the Timbren Rear Suspension Enhancement System #TFR350SDE on your 1997 Ford F-350 Heavy Duty along with the RoadActive Suspension Custom Leaf Spring Enhancement Kit #RAS3611-HD. The RoadActive suspension enhancement (which used to be…

view full answer...

Answer 3

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

view full answer...

Answer 10

I would be happy to! To flat tow your 2024 GMC Canyon Denali you will need the following parts: Tow Bar and Safety Chains - Roadmaster Nighthawk All-Terrain Tow Bar w/ LED Lights item #RM-676 Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit…

view full answer...