Could More than One Camco RhinoFLEX Hose Be Connected to Each Other

Question

Question:

Would one end of this screw on to the other end to make a tight seal? What I'm looking for is a hose to attach to the hose on my grey water tank

asked by: Gary

0

Expert Reply:

Yes, the fittings on the # CAM39765 would allow you to connect a few inline if you wanted. Basically one side of the hose is a male fitting and the other a female so you could keep connecting them and they would seal.

expert reply by: Jameson C

0

Answer 1

The RhinoFLEX RV Sewer Hose Extension with Swivel Lug and Bayonet Fittings #CAM39765 and similar items do have removable orange fittings but there are not replacement parts available. If you have the fittings then you just need the hose #CAM39671.…

view full answer...

Answer 2

The parts included with the Camco RhinoFLEX RV Sewer Hose #CAM39761 will include two storage caps and a 4 in 1 adapter. Here is a breakdown of everything included: 1 15 foot long hose 1 bayonet fitting. 2 storage caps. 1 elbow fitting. 1 4-in-1…

view full answer...

Answer 3

There is an extension piece that you can use with your RhinoFlex sewer hose #CAM39761. It is a 5 foot length, #CAM39765. You could add this to get to 15 feet. I am not sure how much more length you would need but if you need more you could add…

view full answer...

Answer 4

The Westlake ST225/75R15 Radial Trailer Tire w/ 15" Silver Mod Wheel - 6 on 5-1/2 - Load Range E #LHAW124 should be inflated to 80 psi when cold. It is great that you do use a TPMS like #TST-507-FT-4-C that monitors both tire pressure and…

view full answer...

Answer 5

Yes! The RhinoFLEX RV Sewer Hose Extension #CAM39765 is compatible with the RhinoEXTREME RV Sewer Hoses such as #CAM39861. I have linked videos of both products for you.

view full answer...

Answer 6

What you need is the part #CAM39765 that you referenced as well as the fitting part #CAM39852 and you'd have what you are looking for.

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Could More than One Camco RhinoFLEX Hose Be Connected to Each Other

Product Page this Question was Asked From

Continue Researching