Size of the U-Bolts and Nuts Included with Blue Ox Immobilizer BX88224

Question

Question:

WHAT ARE THE U BOLTS SIZE nd the nut size

asked by: J. C

0

Expert Reply:

The u-bolts of the Immobilizer # BX22884 that you referenced are 3/8-16 x 3.25 x 2 SQ U-Bolt, Grd 5 and the nuts are 3/8-16 Hex Flange Whiz Lock Nut.

expert reply by: Jameson C

0

Answer 1

The Blue Ox Hitch Receiver Immobilizer II item #BX88224 does not have any torque specifications. You are just supposed to tighten the whiz nuts firmly so use your best judgement.

view full answer...

Answer 2

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

view full answer...

Answer 3

The usable length of the bolt is right at 3-1/4 inches, or just at 3 inches if the lock washer is used. The Curt #C22321 isn't designed for a 2-1/2 inch receiver, so I'd recommend another option like #BX88312, which is actually designed…

view full answer...

Answer 4

For your 2020 Jeep Gladiator with an off-road bumper with 1 inch D-rings, the best option is absolutely going to be the Blue Ox adapter and tow bar you asked about: - Blue Ox Aftermarket Off-Road Bumper Adapter - 7/8" Pin #BX88357 - Blue Ox…

view full answer...

Answer 5

I believe you are asking about the inside depth on the Blue Ox D-Ring adapter #BX88357, which is 1-5/8 inches. I've attached a photo along with some other measurements for you as well, but if the Warn bumper on your 2012 Wrangler Rubicon is an…

view full answer...

Answer 6

My technical contact at Blue Ox advised that the only adapter kit they offer that could potentially work on your M.O.R.E. aftermarket Jeep bumper is kit #BX88358. He was not familiar with the M.O.R.E. brand of products. There is a MOVE brand of…

view full answer...

Answer 7

You can definitely use the Blue Ox Aftermarket Off-Road Bumper Adapter - 7/8" Pin #BX88357. The 1/16" space you were talking about is not too much play, it is such a small amount it won't be impactful. Drilling the holes out is not…

view full answer...

Answer 8

You are correct that both the #BX88357 and BX88296 (no longer available) are both the same part with the same size specifications. The #BX88357 is just the newer version of the aftermarket bumper adapter so that's the one I recommend using as…

view full answer...