Useable Length of the Hidden Hitch Fifth Wheel Hitch Replacement Pins and Clips # 6014

Question

Question:

Are they 3" long pins or a different length?

asked by: Rich

0

Expert Reply:

I went out to the warehouse and pulled a set of the Hidden Hitch fifth wheel replacement pins # 6014 that you referenced and the measurement from the inner edge of the clip grove to the bend in the pin is 3-1/4 inches. This measurement is what is considered the useable length, where as the length from the outer edge of the clip to the bend is 3-3/4 inches.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The B&W Patriot slider fifth wheel hitch #BWRVK3270 that you referenced weighs a total of 220 lbs. While that is a lot of weight what's great about the B and W hitches is that they break down into smaller sections easily to help distribute…

view full answer...

Answer 2

Yes you can, I spoke with my contact at Curt and he informed me that the Replacement Rail Pins and Clips part #C16902 that you referenced will work on a Reese fifth wheel hitch. These have a diameter of 1/2 inch and are 3-1/4 inches long just like…

view full answer...

Answer 3

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 12

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Useable Length of the Hidden Hitch Fifth Wheel Hitch Replacement Pins and Clips # 6014

Product Page this Question was Asked From

Continue Researching