Recommended Tire Pressure for Kenda 5.70-8 Trailer Tire with White Wheel

Question

Question:

Please would you advise me on the pressure for these tires, is it 100lbs/ft or is that a maximum?

asked by: Andy H

0

Expert Reply:

With trailer tires you have to keep them inflated to the max PSI that's listed on the tire at all times to ensure you get the full weight capacity and you prevent heat build up from causing failure of the tires.

For the part # AM30155 you need to keep 100 psi in them at all times.

expert reply by: Jameson C

0

Answer 1

90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

With trailer tires you need to run them at the max PSI listed on the sidewall to ensure you get the full capacity of the tire and to prevent heat build up in them. For the Kenda 5.70-8 Bias Trailer Tire with 8" White Wheel - 4 on 4 - Load Range…

view full answer...

Answer 4

Trailer tires should always be inflated to the maximum psi indicated on the tire. This is because trailer tires are built with a thicker sidewall to handle more vertical load. If the tire is under inflated that thicker sidewall will cause excessive…

view full answer...

Answer 5

Normally tire speed ratings are listed right after the tire size as a letter. For example the letter M represents and 81 mph speed rating. If you can't find a speed rating after the tire size the safe assumption will be that the tire is limited…

view full answer...

Answer 6

I did some research and it looks like your 1997 Cushman Titan uses 5.70 x 8 tires. The tire/wheel combo I recommend is the Kenda part #AM30155. This combo is a Load Range D mounted on an 8-inch diameter rim with a 5 on 4-1/2 wheel bolt pattern. This…

view full answer...

Answer 7

If the lights you want to replace are stop, turn, tail light, and back up lights, then part #30-92-002 and part #30-92-004 would work for you. I have attached a drawing that shows the dimensions of the two lights mentioned above. These lights measure…

view full answer...

Answer 8

The Taskmaster Provider ST205/75R15 tire you'd looked at, part #TTWTRTM2057515C is indeed tubeless which is typical for a trailer tire. In fact, we don't offer any trailer tires that use inner tubes. Radial tires allow enough flex that the…

view full answer...

Answer 9

It sounds like your 2-3/4" hole measurement comes from the pilot hole diameter and you are comparing that to the 4-1/2" measurement from a 5 on 4-1/2 bolt pattern. When measuring the bolt pattern on a wheel like yours with an odd number of…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Recommended Tire Pressure for Kenda 5.70-8 Trailer Tire with White Wheel

Product Page this Question was Asked From

Continue Researching