Length and Width of Enkay Rock Tamers Mud Flap

Question

Question:

What is the size, width and height of the mud flap?

asked by: Pat

0

Expert Reply:

The length of the Replacement Mud Flap for Enkay Rock Tamers HD Adjustable Mud Flap System # ERTO22 is 24-1/8 inches and the width is 23-7/8 inches.

expert reply by: Jason S

0

click to enlarge

Answer 1

The clamp that you need is the part #ERT048. This attaches the flap to the #ERT045 on your RockTamers Mudflap.

view full answer...

Answer 2

For your 2019 Ford F-250, I recommend the Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness with 7-Pole Plug #41157. This wiring harness is 10 feet long and will connect to your factory harness at your bumper 7-way and will allow you to…

view full answer...

Answer 3

Since the Flash E Series Ball Mounts #FA42-00-2825 have aluminum, solid shanks you would have to use an Immbolizer like part #BX88224 to get rid of the movement between the shank of the ball mount and the hitch. There isn't a device that will…

view full answer...

Answer 4

The heat shield part #RT76FR that you referenced was designed to prevent the type of damage you have on your Rock Tamers mud flap so this would be best solution. Other option is to have a turn down welded to your exhaust tip so that it is directed…

view full answer...

Answer 5

I have a good solution but when using the Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches part #ERT00108 there is not an option that doesn't attach to the ball mount. My thought for you to get the benefits of the Rock…

view full answer...

Answer 6

The correct Rock Tamer Mud Flaps for a 2020 Chevrolet Silverado 2500 is part #ERT00108 for 2" hitch receivers or part #ERT00110 for 2-1/2" hitch receivers. If you don't know what size trailer hitch receiver you have, just measure the…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Length and Width of Enkay Rock Tamers Mud Flap

Product Page this Question was Asked From

Continue Researching