How Long Does Atwood Carbon Monoxide and Propane Gas Detector AT36681 Last

Question

Question:

How often should it be replaced? How long will an Atwood last?

asked by: Deb

1

Helpful Expert Reply:

The Atwood carbon monoxide/LP gas detector # AT36681 has a 7-year lifespan. That is assuming that it is regularly maintained according to the manual, linked for reference. Be sure to test the detector often to ensure it is functioning properly.

Provided that the unit is functioning properly and within its lifespan you would not have to change it. But at around 7 years, even if working perfectly, it would be time to get a new one. This information is specifically for these models so be sure to check the specs on any other models you may be interested in.

expert reply by: Michael H

1

Answer 1

We have exactly what you are looking for. You will want the Atwood combination gas and carbon monoxide detector #AT36681.

view full answer...

Answer 2

The Atwood 2001 Protechtor you have is for detecting just propane whereas the part #AT36681 detects propane and carbon monoxide.

view full answer...

Answer 3

The trim ring is not available, but the Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 can be mounted quite simply without it. I attached a page from the directions which shows how this is done; you simply remove the bezel from the…

view full answer...

Answer 4

The Atwood RV Carbon Monoxide and Propane Gas Detector part #AT36681 has three wires as you mentioned but only two will need to be used. There are two red wires and one black wire. The black wire is ground and the two red wires are for power. Only…

view full answer...

Answer 5

We've seen this issue before on your Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 and the beeping every 40 seconds indicates "a fault has been detected that compromises some detector function." What you need…

view full answer...

Answer 6

For a replacement combination LP Gas/CO detector for your RV you can use Atwood part #AT36681. It is intended for installation at no more than 18" from the floor and both include a mounting plate.

view full answer...

Answer 7

The lifespan of Atwood carbon monoxide and LP sensors like the part #AT36681 that you referenced is 7 years so if you are having alarms go off at 2-1/2 years I'd recommend taking the alarms seriously. You can also make sure the batteries that it…

view full answer...

Answer 8

I spoke with a contact at Atwood. The main concern for the GS961LP is ensuring that it receives 12V power. Because the Atwood LP Gas Detector RV 12V White 36719 has this, it's highly possible that it can work for you. However, we do not sell this…

view full answer...

Answer 9

I went out to our warehouse to check for you, however the Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 units are bubble packaged so I can't get that information for you. Regardless of that date you are seeking they come with a 2…

view full answer...

Answer 10

I reached out to my contact at Atwood, and they advised me that the Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 will not harm or cause any problems when disconnecting or removing your 12 V battery.

view full answer...

Answer 11

It sounds like your Atwood RV Carbon Monoxide and Propane Gas Detector part #AT36681 is hooked up properly and is getting power. The code you hear is like you said a fault code in this case because of the audible tone. I recommend replacing it. The…

view full answer...

Answer 12

When replacing your existing detector with the Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 you will not need to disconnect the 12V trailer batteries. It also does not matter which of the two power wires you connect first. The third…

view full answer...

How Long Does Atwood Carbon Monoxide and Propane Gas Detector AT36681 Last

Continue Researching