Compatibility of Brophy Camper Tie Down # HSSF in a 2010 Dodge Ram 1500

Question

Question:

WILL THE TIE DOWNS WORK ON A 2010 DODGE RAM 1500. HOW MUCH WIEGHT WILL THEY KEEP SECURE

asked by: BILL M

0

Expert Reply:

These Brophy Camper Tie Down, part # HSSF, are universal fit items so they would work on your 2010 Dodge Ram 1500. There is not a weight capacity on these hold downs either, and they should work on any camper that is a correct fit for your vehicle.

expert reply by: Jameson C

0

Answer 1

On the ends of the Brophy tie downs #HSAB where you would tie off the camper the tip is turn up to be parallel with the ground. The angled design allows more clearance between hold-downs and truck fenders.On #HSSF the tips are not turn up and are…

view full answer...

Answer 2

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors…

view full answer...

Answer 3

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory…

view full answer...

Answer 4

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 5

You can definitely install the HappiJac tie-downs in the front and use Torklift tie-downs for the rear, but you'll have to purchase the whole Happijac kit #LC236326-205221 since we don't currently offer the front separately. For the…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The proper extension for your setup would be the one that allows you to have clearance of your hitch mounted accessory and also allows you to still be able to pull the steps down. If the receiver tube sticks out past the camper too far then you will…

view full answer...

Answer 8

Yes, the Brophy camper tie downs like the #HSAB can be used with bed rail covers. If you check out the picture I attached you can see a set installed on a bed rail with plastic covers.

view full answer...

Answer 9

There are times when it is tough to locate the brake controller plug under the dash. On the 2015 Ram the factory plug is located between the brake pedal and the emergency brake pedal as shown in the attached photo. It is probably behind another…

view full answer...

Answer 10

Your trailer looks awesome! The Road armor equalizers #LC696740 and Equa-Flex Cushioned Equalizers #LC279687 are both pretty similar in performance even though the Road Armor has two dampers. The main difference is the size of the equalizers. The…

view full answer...

Answer 11

Hey Michael, yes the Extang replacement tarp part #EX92430-20 is the correct replacement fabric tarp for the Extang Trifecta that fits your 2015 Ram 5100 6-1/2 foot bed.

view full answer...

Compatibility of Brophy Camper Tie Down # HSSF in a 2010 Dodge Ram 1500

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching