How To Remove the Air Line From the Air Lift Union T-Piece Part # AL21838
Question:
I am going to take my Air Lift 5000 AL57204 off / out of my current 2013 GMC Sierra 4X4 and reinstall them in a 2016 Chevrolet 1500 4X4. I am currently using one of these T- Unions . Is there a way to get the air lines out of the compression / slip on fittings and then be able to reuse them ?
asked by: Rick S
Expert Reply:
Keeping the airbags at the 5 psi minimum while not in use will allow the bags to retain their shape properly and not end up folded over or in any other position that might cause a portion of the bag to wear out prematurely.
I am curious as to how you are measuring the amount of air in the airbags. I would also like to see a photo of the airbags installed and inflated to 5 psi while on your truck. If you can provide me with this information I may be able to provide further advice.
Products Referenced in This Question
Replacement Air Line Kit for Air Lift LoadLifter 5000, LoadLifter 5000 Ultimate, and Ride Control
- Accessories and Parts
- Air Suspension Compressor Kit
- Vehicle Suspension
- Air Lines
- Tubing
- Air Lift
more information >
Air Lift Union Tee for 1/4" Air Lines
- Accessories and Parts
- Air Suspension Compressor Kit
- Vehicle Suspension
- Connectors
- 1/4 Inch Tubing
- Union Tee
- Air Lift
more information >
Air Lift WirelessONE Compressor System for Air Helper Springs - Remote - Bluetooth - Single Path
- Air Suspension Compressor Kit
- Wireless Control
- Single Path
- Digital Display
- 100 psi
- Air Lift
more information >
Product Page this Question was Asked From
Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Air Springs
- Heavy Duty
- Air Lift
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: TorkLift SuperHitch Magnum Trailer Hitch Receiver - Custom Fit - Class V - 2-1/2" and 2"
- Video: TorkLift SuperHitch Trailer Hitch Installation - 2017 Chevrolet Silverado 3500
- Shop: Camper Tie-Downs
- Search Results: torklift camper
- Search Results: c2220
- Shop: TorkLift SuperTruss Hitch Extension for SuperHitch Trailer Hitch Receivers - 36" Long
- Shop: B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Shop: TorkLift Camper Tie-Downs - Custom Frame Mount - Front
- Shop: TorkLift Talon Camper Tie-Downs - Custom Frame Mount - Aluminum - Rear
- Shop: TorkLift Camper Tie-Downs - Custom Frame Mount - Rear
- Shop: B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Search Results: torklift
- Search Results: superhitch magnum
- Shop: Suspension Enhancement
- Video: Review of Air Lift Vehicle Suspension - Rear Axle Suspension Enhancement - AL59565
- Video: Air Lift Vehicle Suspension AL20086 Review
- Shop: Windshield Covers
- Q&A: How to Remove Hose Line from Fitting for Air Lift Load Controller Compressor System
- Video: Review of Air Lift Replacement Air Spring - AL50292
- Video: Hollywood Racks LED Light Bar Review
- Video: Best 2012 GMC Sierra Vehicle Suspension Options
- Video: Air Lift Union T-Piece Review
- Search Results: truck camper dolly
- Q&A: Union T Recommendation for Air Lift Suspension System to Inflate Two Air Bags at a Time
- Q&A: Replacing Manual Inflation Valves on Air Spring System
- Q&A: What Size Drill Bit is Needed for TorkLift Stableload
- Q&A: Should Air Bags Be Filled Before Or After The Truck has Been Loaded?
- Q&A: Best Weight Distribution Hitch System For a ATC Trailer With 2" X 8" Tall Frame Rails
- Q&A: Spacer Kit to Be Used with Air Lift Suspension Enhancement for 2013 GMC Sierra with 2 inch Lift
Rick S.
9/12/2017
I am going to take my Air Lift 5000 AL57204 off / out of my current 2013 GMC Sierra 4X4 and reinstall them in a 2016 Chevrolet 1500 4X4. I am currently using one of these T- Unions . Is there a way to get the air lines out of the compression / slip on fittings and then be able to reuse them ?