Needing a Replacement Key for the Thule Lock Housing of the Thule Snug Tite Hitch Lock

Question

Question:

What replacement key do I get for this Thule lock housing # 753-3725-02 ?

asked by: Christine M

0

Expert Reply:

To find a replacement key of the lock housing of the Thule Snug Tite Hitch Lock, # THSTL2, there is a number that is engraved on the lock face of the lock cylinder that is installed in the lock housing.

The number is usually an alpha numeric number that will start with the letter N, like N2862. As an example, if your lock has number N2862, then the replacement key would be , # THKEYN2862.

The attached link lists all the Thule keys that we carry. Just match the number on the lock to the key on the product page.

expert reply by: Jared P

0

Answer 1

The Master Lock Hitch Receiver and Coupler Latch Lock Set - Padlock - 1-1/4" and 2" Hitches #2848DAT has replacement keys if you know the key number using #MLK1. If you do not know your key number, unfortunately there is no way to determine…

view full answer...

Answer 2

The correct replacement wheel tray for the Thule T2 Classic 2 Bike Platform Rack part #TH9045 or part #TH9044 or the #TH9044-TH9046. s the Replacement Tire Wheel Tray part #8523598001 for front or part #7521568001 for rear. The Replacement Tire Wheel…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 10

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

view full answer...