Troubleshooting Axle Alignment Issue on Tandem Axle EZ Loader Trailer
Question:
Hi. I recently replaced and axle on a 1988 tandem axle ez loader trailer. After the replacement one wheel sticks out about an inch mote on one side. What could cause this?
asked by: Kyle
Expert Reply:
It sounds like you may have a replacement axle that wasn't fitted properly. You will want to make sure you have matching axles as that natural misalignment will cause tire wear issues and can lead to sway issues as well. I've linked the page to all of our axle options to assist. You will want to measure from hub face to hub face on each axle and from spring seat to spring seat center to determine the correct fit. I've linked the page to the options for replacement. You will also want to make sure your tires and wheel are all the same as that could also account for the inch difference.
If they are different, you will need to replace one or both to get a matching set. If they are the same, then you will want to realign your axles at the spring seats and springs at hangers to determine why the shift and correct it.
Product Page this Question was Asked From
Trailer Axle w/ Electric Brakes - Easy Grease - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Easy Lube Spindles
- Electric Brakes
- 3500 lbs
- 5 on 4-1/2 Inch
- 74 Inch Long
- 89 Inch Long
- No Drop or Lift
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Axle w/ Electric Brakes - Easy Grease - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs
- Search Results: spring seats
- Search Results: springs
- Search Results: axles
- Q&A: Replacement 3,500 Pound Axle With 68-1/2" Spring Center for 2018 Grand Design Imagine Travel Trailer
- Q&A: Availability of Replacement for Trailer Hub/Brake Drum 92865A-1
- Shop: Trailer Axle Beam with Easy Grease Spindles - 89" Long - 3,500 lbs
- Shop: Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs
- Shop: Dexter Trailer Axle Beam with E-Z Lube Spindles - 86-1/2" Long - 5,200 lbs
- Shop: Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 1-1/4" Rear
- Shop: Dexter Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs
- Shop: Spring Seat for Typical 3,500-lb, Round Trailer Axles with 2-3/8" Diameter
- Search Results: 8k axle
- Search Results: dexter 8000 lb axle
- Search Results: k23~464~00
- Q&A: Troubleshooting Trailer Tandem Trailer Axles Where One Is Closer to Trailer Frame than Other
- Q&A: Troubleshooting Tandem Axle Trailer Alignment on One Side of Trailer
- Q&A: Troubleshooting Trailer Suspension that Shackle and Equalizer Flip Over
- Q&A: Shackle Straps Break on a 20ft Tandem Axle Trailer and the Rear Axle Slides the Tires
- Search Results: bearing buddy 1980
- Q&A: Oil Seal With 1.68 Outer Diameter And 2.56 Hub Inside Diameter
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Shop: Trailer Wiring
- Article: Most Popular Wheel Bearings
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Shop: Brake Controller
- Article: How to Accurately Measure Trailer Leaf Springs
- Shop: Suspension Enhancement
on Trailer Suspension Parts
