Replacement Bearings for 2009 StarCraft Travel Star Travel Trailer

Question

Question:

do you have a bearings for vr starcraft travel star 2009, what is the number for a bearing

asked by: Juliecharron

0

Expert Reply:

We aren't able to determine which bearings your trailer has just by the make and model of the trailer. You'll need to pull the hubs and check the bearing numbers or measure the spindles where the bearings sit. Then you can use that to find the correct bearings you need.

I've linked our selection of bearings as well as an article over the most popular parts.

expert reply by: Charles S

0

Answer 1

Since there is no standard set of bearings for a trailer you will have to do one of two things. You can pull a wheel and hub and check the bearings you have on one spindle. The numbers will typically be found stamped on the side of the bearings as…

view full answer...

Answer 2

I looked through all of the replacement lenses that we have and none are a match for what you are looking for. I wish I had better news for you.

view full answer...

Answer 3

Yes, the adapter part #C57003 will fix any bulb out error codes on the dash of your vehicle caused by trying to tow a trailer with LED lights.

view full answer...

Answer 4

Torsion axles use internal rubber cords to provide the suspension motion and they really are not practical to repair/rebuild. Certainly any axle that was damaged in an accident should be replaced purely for safety reasons. It is potentially possible…

view full answer...

Answer 5

If the leaf spring part #e57SR that you referenced matches up dimensionally to what your trailer has and has a capacity that is 400 lbs more than needed it would work just fine. Having a bit extra capacity for the leaf springs would not cause an…

view full answer...

Answer 6

It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…

view full answer...

Answer 7

I called Dexter and they told me that your Dexter P-12 SLR SN: D5287869 axle has a 3,000 lb weight capacity. If you need any parts please let me know what they are and I would be happy to offer my recommendation.

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement Bearings for 2009 StarCraft Travel Star Travel Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching