Will SuperSprings Suspension # SSA1 Interfere with Emergency Brake Cables on a 2001 Toyota Tacoma

Question

Question:

will the e-brake cables that route to each back wheel get in the way of adding these supersprings. the e-brake cables look like they are routed just above the existing leaf springs.

asked by: Jeff B

0

Expert Reply:

When installing Super Springs Suspension Enhancement, # SSA1, anything that that is in the area where the springs will mount will need to be relocated, if possible, so that the action of the spring does not damage it. I have included a link to the installation details for you to view so you can get a better idea of where the springs will be once installed.

expert reply by: Michael H

0

Answer 1

Since you will be towing a travel trailer, which is a static load that does not change weights all of the time, I recommend going with leaf springs, see link. If you have a 2 wheel drive model that is not a Pre-Runner, go with #SSA1 for 2,000 pound…

view full answer...

Answer 2

There isn't a special kit you would have to use to install battery isolator on your 2015 Toyota Tacoma unless it uses a Delco or GM CS alternator (which isn't likely). So you would use the regular kit, #DW08769.

view full answer...

Answer 3

The Deka Battery Isolator #DW08770 is not vehicle-specific; it will work fine on your 1986 Dodge Ramcharger to protect the truck battery from excessive discharge and to regulate current in a multi-battery system. If your truck has a CS alternator you…

view full answer...

Answer 4

When installing the Deka Battery Isolator - 120 Amp #DW08771 you actually do not tap into the ignition systems. Instead you will run the wire from the alternator to the A post on the Isolator, then run a wire from the number 1 post of the isolator to…

view full answer...

Answer 5

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...