Review of Deka Battery Charger - 95 Amp Battery Isolator - DW08770 Video

When installing the Deka Battery Isolator - 120 Amp #DW08771 you actually do not tap into the ignition systems. Instead you will run the wire from the alternator to the A post on the Isolator, then run a wire from the number 1 post of the isolator to…

Since you will be towing a travel trailer, which is a static load that does not change weights all of the time, I recommend going with leaf springs, see link. If you have a 2 wheel drive model that is not a Pre-Runner, go with #SSA1 for 2,000 pound…

There isn't a special kit you would have to use to install battery isolator on your 2015 Toyota Tacoma unless it uses a Delco or GM CS alternator (which isn't likely). So you would use the regular kit, #DW08769.

When installing Super Springs Suspension Enhancement, #SSA1, anything that that is in the area where the springs will mount will need to be relocated, if possible, so that the action of the spring does not damage it. I have included a link to the…

The Deka Battery Isolator #DW08770 is not vehicle-specific; it will work fine on your 1986 Dodge Ramcharger to protect the truck battery from excessive discharge and to regulate current in a multi-battery system. If your truck has a CS alternator you…

The Deka Battery Isolator - 95 Amp #DW08770 does require the ignition switch be connected to the E post. This is how you ensure the batteries are isolated and the auxiliary battery does not draw power from the starting battery. You will want to use a…

The light that indicates that the 12 volt circuit is hot is normal and it will not drain the battery. Think of it as the battery having a really long positive terminal that just extends to the rear of the vehicle. If nothing is drawing power from it,…

The only wires that could be hot all the time on a trailer connector is the 12-volt hot lead, which is usually a black wire, and, if applicable, the auxiliary power wire, which is normally yellow or purple. The blue wire is usually for electric…

The Solera Slide Toppers we have available, such as the 10.5' #LCV000168105 that you were looking at, do not include caulk like #0160297 or butyl tape but it can be added with part #CAM25013. The Slide-Toppers include the awning itself, mounting…

A trailer mounted battery is typically maintained by the 12-volt accessory circuit from the 7-way trailer connector. If the accessory circuit on your 7-way is live even when the ignition is shut off, it is possible that the battery on your truck…

You are correct when using the DEKA isolator part #DW08771 on a vehicle like yours you wouldn't use the E post.

I may have a solution for you, however we do not have any A-Frame trailer jacks with a mounting hole pattern like yours. All of our jacks fit the standard A-Frame bolt hole pattern which put the bolt holes between 3 inches to 3-5/8 inches apart on…