Availability of the Stabilizer Strips to Install the Hi-Rise Gooseneck to 5th Wheel Adapter on Fords

Question

Question:

do you sell the Stabilizer Strips for the 9480 used on ford trucks 3/8inch x 36

asked by: Craig

0

Expert Reply:

Yes, the part you will need is the Stabilizer Strip Kit for Fifth Wheel Conversion Kits for Ford Trucks, # 58438.

expert reply by: Jared P

0

Answer 1

Yes, the heat shield on your 2017 Chevrolet Silverado 3500 while installing the B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit part #BWGNRK1016 will need to be removed and then discarded. The heat shield is not…

view full answer...

Answer 2

The B&W Companion Slider Gooseneck-to-5th-Wheel Trailer Hitch Adapter part #BWRVK3400 is a direct fit for the B&W Turnoverball Underbed Gooseneck Trailer Hitch part #BWGNRK1108 that you have on your 2008 Ford F-350, there is no…

view full answer...

Answer 3

The Firestone Sport-Rite Air Helper Springs you mentioned F2320, along with the Reese Quick-Install Custom Outboard Brackets for 5th Wheel Trailer Hitches #RP56007 are not compatible on your 2003 Chevrolet Silverado Z71 1500. I contacted the…

view full answer...

Answer 4

The Air Lift LoadLifter 5000 Air Helper Springs part #AL57275 are a confirmed fit for a 2005 Chevrolet Silverado 1500 4x4. If you have a 2005 Chevrolet Silverado 4x2 then you will want to use the Air Lift Ride Control Air Helper Springs part #AL59501…

view full answer...

Answer 5

Yes, the Air Lift Ride Control Air Helper Springs #AL59501 will fit your 2003 Chevy Silverado 1500HD, you simply need to make sure you have at least 6 inches from the outside of the frame to the inside of the tire, as you can see by the cut out of…

view full answer...

Answer 6

The listed towing capacity of your 2004 Chevy Silverado LS short bed with 5.3L engine is going to vary depending on some specifics of the vehicle. If the Silverado is four-wheel drive and has a 3.73:1 axle ratio, the capacity is 7,800 lbs (extended…

view full answer...

Answer 7

Yes, to use the Draw-Tite Hi-Rise Gooseneck-to-5th-Wheel Trailer Hitch #9480 referenced in your question on your 2012 F-250 you will need to use the thinner strips from the Stabilizer Strip Kit #58438. This will allow the hitch to sit properly…

view full answer...

Answer 8

If you are wanting to keep the bed of your 2003 Chevy Silverado 1500 clean then I highly recommend using the B&W Companion #BWRVK3400-5W because it mounts in the B&W Gooseneck Hitch #BWGNRK1059-5W. Instead of having bed rails in the bed of…

view full answer...

Answer 9

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 10

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 11

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Availability of the Stabilizer Strips to Install the Hi-Rise Gooseneck to 5th Wheel Adapter on Fords

Products Referenced in This Question

Continue Researching