Replacement Gear Motor for Ultra-Fab Trailer Jack

Question

Question:

Need motor-gear assembly for ultra fab 5th wheel jack # 10000, serial#06031 Please advise, thanks

asked by: Ron M

0

Expert Reply:

For a replacement motor and gearbox for your Ultra-Fab powered 5th wheel jack you can use part # UF39-750009 if you have either stabilizer model # UF39-941705 or # UF39-941707. All Ultra-Fab parts are displayed on the linked page.

expert reply by: Adam R

0

Answer 1

Yes, the Lippert Components Heavy Duty Landing Gear Motor part #LC196308 would be a more dependable option than the Lippert Components High Speed Landing Gear Motor part #LC141893 that you have now. This motor has a higher weight capacity (6,500 lbs…

view full answer...

Answer 2

Good question; if for some reason there is an issue with the power or motor, you can manually operate the Ultra-Fab Deluxe Electric Landing Gear Set #UF17-943010. I took a look at the instructions, and the accompanying cut out from them explains what…

view full answer...

Answer 3

For a 13K 5th wheel the Bulldog Tandem Landing Gear Set #BD500162, which is rated for 8000-lbs, will be more than adequate. According to my contact at Bulldog they do not offer a motor kit for this particular jack. For powered landing gear you might…

view full answer...

Answer 4

I spoke with my contact at Bulldog and he said that he has heard of people using the landing gear motor part #75391 with the Bulldog jacks part #BD500162 that you referenced. But since they have not fully tested this they can't guarantee it will…

view full answer...

Answer 5

To replace the motor and gear box on the Ultra-Fab Power Twin II Electric Stabilizer, part #UF39-941705 or #UF39-941707, you will want to use the Replacement Motor and Gear Box Assembly for Ultra-Fab Power Twin II Electric Stablizers #UF39-750009.

view full answer...

Answer 6

Ultra-Fab Stabilizer Jack #UF39-941707 will bolt onto a trailer using the bolt holes that are present on the mounting flanges of this jack as well as with the included nuts and bolts. You will most likely have to drill holes in the frame of your…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 11

To determine the best landing gear option for your 1997 Forest River Sierra you'll need to measure the where your weld-stops sit to see if there is a matching set so that you can swap over without having to cut off the old mounting brackets and…

view full answer...

Replacement Gear Motor for Ultra-Fab Trailer Jack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching