Replacement Pads For 4 Inch Wide Nerf Bars With 24 Inch Step Pad

Question

Question:

I have a 5 pin 4 inch wide 24 inch longoriginal equip nerf barb step pad thats broken do you have a replacement.

asked by: Anthony C

0

Expert Reply:

It sounds like you need the Replacement Step Pad for Westin Platinum Series Oval Nerf Bars - Front/Rear - Qty 1 # 21-0001. You can see the measurements in the photo and that there are 6 pegs, but only 5 of them use the clips to hold the pads in place. You will also need 5 barrel clips, # 23-0002. The clips are sold as singles so you will need to change the quantity to 5.

expert reply by: Jason S

0

click to enlarge

Answer 1

With 5 holes, you most likely have Westin nerf bars. I recommend the Replacement Step Pad for Westin Platinum Series Oval Nerf Bars - Front/Rear - Qty 1 #21-0001 which are 24 inches by 4 inches.

view full answer...

Answer 2

We have a large selection of replacement step pads available for running boards like what are on your 2013 Toyota Tacoma. I cannot be positive as to what brand and model running boards you have, but we do have a replacement step pad available with…

view full answer...

Answer 3

We don't have any replacement pads for your Truck Champ brand nerf bars based on your hole locations and measurements. However, since you don't have a perfect replacement option, I recommend the Replacement Step Pad for Westin…

view full answer...

Answer 4

Without knowing the exact brand and model nerf bars you have it will be difficult to correctly match up step pads. According to your measurements, the closest one we have is the Replacement Step Pad for Aries 4" Wide Oval Nerf Bars…

view full answer...

Answer 5

The Westin Replacement E-series Step Pad, #23-0001, measures 3-5/8, 5-5/8, 6-3/8, 3-5/8 inches from one end pin to the other. I have attached a photo showing the measurements I took for you. It is 21 inches long and 3 inches wide. This certainly does…

view full answer...

Answer 6

These Replacement Step Pads are for Westin Nerf Bars #21-0001 but are 4 inches wide and 2 inches long. They have tabs on the sides so if these look like the same set up as yours. Nerf Bars are usually pretty similar. We do not have the exact…

view full answer...

Answer 7

I spoke with my contact at Westin. She stated that the Replacement Step Pad for Westin Platinum Series Oval Nerf Bars, #21-0001, is 24 inches long. It is also 4 inches wide.

view full answer...

Answer 8

When you need to remove the step pad like part #21-0001 from an oval Nerf bar, there really is no way to gently take them off. I have attached a video that shows how the old pad is removed and also shows how the new pad is to be installed. As the…

view full answer...

Answer 9

The replacement step pads you need for the Westin Platinum Oval series are #21-0001. You may also want the Replacement Barrel Clip for Westin Platinum Series #23-0002.

view full answer...

Answer 10

There are many step pad replacements available for nerf bars and each one has a slightly different measurement and mounting pin locations. For instance, I've attached the Replacement Step Pad for Westin E-Series Nerf Bars - 21" Long x…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement Pads For 4 Inch Wide Nerf Bars With 24 Inch Step Pad

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching