Dimensions of Replacement Step Pad for Westin Platinum Series Oval Nerf Bars, # 21-0001

Question

Question:

What is the length of this pad?

asked by: Andrew

0

Expert Reply:

I spoke with my contact at Westin. She stated that the Replacement Step Pad for Westin Platinum Series Oval Nerf Bars, # 21-0001, is 24 inches long. It is also 4 inches wide.

expert reply by: Michael H

0

Answer 1

The Replacement Step Pad #21-0001 that you referenced is ambidextrous, meaning it can be used on the tube steps on both the left and right hand side of the vehicle.

view full answer...

Answer 2

It sounds like you need the Replacement Step Pad for Westin Platinum Series Oval Nerf Bars - Front/Rear - Qty 1 #21-0001. You can see the measurements in the photo and that there are 6 pegs, but only 5 of them use the clips to hold the pads in place.…

view full answer...

Answer 3

Without knowing the exact brand and model nerf bars you have it will be difficult to correctly match up step pads. According to your measurements, the closest one we have is the Replacement Step Pad for Aries 4" Wide Oval Nerf Bars #AA2090161…

view full answer...

Answer 4

We don't have any replacement pads for your Truck Champ brand nerf bars based on your hole locations and measurements. However, since you don't have a perfect replacement option, I recommend the Replacement Step Pad for Westin Platinum Series…

view full answer...

Answer 5

When you need to remove the step pad like part #21-0001 from an oval Nerf bar, there really is no way to gently take them off. I have attached a video that shows how the old pad is removed and also shows how the new pad is to be installed. As the…

view full answer...

Answer 6

The replacement step pads you need for the Westin Platinum Oval series are #21-0001. You may also want the Replacement Barrel Clip for Westin Platinum Series #23-0002.

view full answer...

Answer 7

There are many step pad replacements available for nerf bars and each one has a slightly different measurement and mounting pin locations. For instance, I've attached the Replacement Step Pad for Westin E-Series Nerf Bars - 21" Long x…

view full answer...

Answer 8

These Replacement Step Pads are for Westin Nerf Bars #21-0001 but are 4 inches wide and 2 inches long. They have tabs on the sides so if these look like the same set up as yours. Nerf Bars are usually pretty similar. We do not have the exact…

view full answer...

Answer 9

The Westin Replacement E-series Step Pad, #23-0001, measures 3-5/8, 5-5/8, 6-3/8, 3-5/8 inches from one end pin to the other. I have attached a photo showing the measurements I took for you. It is 21 inches long and 3 inches wide. This certainly does…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Dimensions of Replacement Step Pad for Westin Platinum Series Oval Nerf Bars, # 21-0001

Product Page this Question was Asked From

Continue Researching