Does Titan Model 60 Disc Brake Master Cylinder Include Orifice Connector

Question

Question:

Purchased Titan model 60 disc brake master cylinder and reverse lockout. Is the orafice supplied with the kit for disc brakes? What is the size of the orafice supplied with kit? Thank you.

asked by: Daniel

0

Expert Reply:

The Titan model 60 disc brake actuator master cylinder # T4820000 does include the orifice connector, part # T1209800, which has a 1/8-inch pipe thread male end and a 3/16-inch brake line fitting.

expert reply by: Adam R

0

Answer 1

If you are talking about the small opening on the outside and inside of the Orifice Connector #T1209800 then those measure 0.0010" and 0.0865" respectfully. I went out to the warehouse and measured them with the digital caliper. Please note…

view full answer...

Answer 2

Orifice Connector #T1209800 is for drum brakes. It is the new style with 1/8" NPT threads. For disc brakes you would need #T4750300. Drum brakes actually do not take the larger hole. Drum brakes require around 1000 psi whereas disc brakes…

view full answer...

Answer 3

The small opening in master cylinder fittings like #T1209800 is designed to provide the proper amount of fluid and pressure through the brake lines. Bleeding trailer brakes manually is difficult. You could use a power brake bleeder, vacuum style…

view full answer...

Answer 4

Yes, I spoke with my contact at Titan and after you remove the small orifice fitting part #T1209800 from your Titan model 6 actuator you would be able to install the Lockout Solenoid part #T4748800 and your brakes will activate correctly.

view full answer...

Answer 5

The replacement orifice connector for that Titan model 20 master cylinder is part #T1209800.

view full answer...

Answer 6

If your trailer wants to slam forward and back as you apply the brakes of your tow vehicle the shock is bad and needs to be replaced. When a shock goes bad it no longer dampens the movement of the actuator which causes what I described. If the shock…

view full answer...

Answer 7

The Orifice Connector for Titan Actuators #T1209800 is not recommended for use with disc brakes; this connector fits Titan Models 6, 10, and 20 Titan actuators for drum brakes.

view full answer...

Answer 8

The part you are looking for is the Brass Connector for Titan Disc Brake Kit, #T4750300. This is the fitting that threads into the master cylinder that accepts the reverse lockout solenoid on your Titan actuator. I have attached a link to this part…

view full answer...

Answer 9

On the Titan Zinc-Plated Brake Actuator #T43397007K you can get access to the plunger for purposes of bleeding the system of air by removing the plate that surrounds the breakaway lever and by removing the front plate with the logo. You can then…

view full answer...

Answer 10

Yes, the replacement 23744 master cylinder with the 5 underneath is the same as your no longer offered Master Cylinder for Titan Model 10 and 20 Actuators #T2374400 with the 1 underneath. The numbers underneath just denote what manufacturing facility…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...