Parts Needed to Flat Tow a 1994 and 1997 Jeep Wrangler Behind a Class C Motorhome
Question:
what kind of a bumper will i need and what type base plate would recommend to use. what tow bar would you recommend? The vehicle weights approximately 3200 - 3500 lbs. will the bulldog bumper fit and can I flat tow or dingy behind an rv.
asked by: Roger M
Expert Reply:
The Bulldog Stubby Bumper # BDW21000 is not rated for flat towing. I spoke to Bulldog about using it to flat tow and they said they haven't tested it long-term in that fashion but if the bumper is reinforced it could be used. It is confirmed to fit both the 1994 and 1997 Jeep Wranglers you have.
The Bulldog Stubby bumper has 3/4 inch shackles so you can use the Roadmaster Adapters # RM-035 to connect to a tow bar. The tow bar I recommend is the Roadmaster Falcon 2 # RM-520 and safety cables # RM-643.
If you'd like to use magnetic lights so you can use them with whichever of the two Jeeps you're towing then use the Optronics Magnetic Tow Lights # TL21RK. They're not a permanent install and they're easy to setup. If you'd rather a hardwire permanent install both Jeeps will use the # RM-15267 diode kit. If you use the diode kit both of them will need the Brake-Lite Relay # RM-88400 to keep their lights from overriding the RV's.
The supplemental braking system I recommend is the Roadmaster Even Brake, part # RM-9400. It's portable so it's easy to transfer between two different vehicles.
Finally, you'll likely need a high-low adapter. I've attached an article to help you determine the correct rise or drop your setup requires. I've also linked our selection of adapters for you to look at once you know what you need.
In addition to my recommendations I've linked some articles on flat towing that you may find helpful.
Products Referenced in This Question
Adapter for Jeep D-Ring Bumper Mounts to Roadmaster Motor Home Mount Tow Bars - 3/4" Thick
- Base Plates
- Aftermarket Bumper Adapters
- Hitch Pin Attachment
- Roadmaster
more information >
Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Diode Kit
- Universal
- Tail Light Mount
- Roadmaster
more information >
Roadmaster Falcon 2 Tow Bar - RV Mount - 2" Hitch - 6,000 lbs
- Tow Bar
- Hitch Mount Style
- Telescoping
- Steel
- 6000 lbs
- Fits Roadmaster Base Plates - Crossbar
- Fits Roadmaster Base Plates - Direct Connect
- Stores on RV
- Standard
- Roadmaster
more information >
RoadMaster 68" Single Hook, Coiled Safety Cables - 6,000 lbs
- Safety Cables
- Coiled Cables
- 68 Inch Long
- 6000 lbs GTW
- Snap Hooks
- Coated Cables
- Roadmaster
more information >
Roadmaster Brake-Lite Relay Kit for Towed Vehicles
- Tow Bar Braking Systems
- Brake Light Relay
- Roadmaster
more information >
Roadmaster Even Brake Portable Flat Tow Brake System - Proportional
- Tow Bar Braking Systems
- Brake Systems
- Proportional System
- Recurring Set-Up
- Portable System
- Not Power Assist Brake Compatible
- Air Brakes
- Air Over Hydraulic Brakes
- Hydraulic Brakes
- Roadmaster
more information >
Heavy Duty Magnetic Tow Lights - 20' Wiring Harness with 4-Way Flat Trailer Connector
- Tow Bar Wiring
- Bypasses Vehicle Wiring
- Removable Tail Light Kit
- 20 Foot Long Harness
- Universal
- Magnetic Mount
- Optronics
more information >