Gear Box Replacement Recommendation for 2007 Crossroad Cruiser Fifth Wheel

Question

Question:

The plastic gearbox on our 2007 Crossroad Cruiser 5th wheel needs to be replaced. Will the part LC276602 work for that replacemen? The motor works fine. Thank you.

asked by: Bill W

0

Expert Reply:

Can you see what brand gear box it is? If the picture of the # LC276602 matches what your gear box looks like it most likely is exactly what you need. Especially if you can see the brands Venture, Atwood, Lippert, and Stromberg-Carlson as well. This is a very common landing gear box so I am very confident this will end up being the correct replacement.

This is an aluminum gear box which will be a bit stronger than the plastic one you had.

expert reply by: Jameson C

0

Answer 1

The Landing Gear Set w/ Handle part #RVLG-8HDL is a very common replacement. The biggest thing to check is the distance from the outside to the outside of the weld stops or inside to inside of the attachment straps to ensure that it measures…

view full answer...

Answer 2

Most landing gear is interchangeable but I can help you measure your existing landing gear to make sure you are getting the correct one that will bolt up to your existing brackets. You would just need to measure from the Crossroads mounting…

view full answer...

Answer 3

Most likely yes, but you'd need to measure the current mounting brackets of your landing gear to know if the #RVLG-8000 is going to fit and work well. Compare the measurements to the picture I attached and if your mounting brackets match this…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 9

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 10

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Gear Box Replacement Recommendation for 2007 Crossroad Cruiser Fifth Wheel

Product Page this Question was Asked From

Continue Researching