What is the Size of the Anti-Rattle Bolt for the Thule Roadway 2 Bike Rack TH912XTR

Question

Question:

What is the size of the anti-rattle bolt that screws into the hitch for stability?

asked by: Ck

0

Expert Reply:

The size of the anti-rattle bolt for the Thule Roadway 2 Bike Rack # TH912XTR can be found with part # THSTL2. The pin itself has a 1/2 inch diameter, has an overall length of 4-1/2 inches, and the threaded part is 1-3/8 inches long.

expert reply by: Jon G

0

Answer 1

Using a hitch extender does cut the tongue weight capacity of the vehicle it is installed in by 50 percent. Since yours is rated for 350 lbs you'd be limited to 175 lb but we do have a 14 inch hitch extender with the Gen-Y part #GY89SR which…

view full answer...

Answer 2

Yes, the Kuat Sherpa 2.0 Bike Rack for 2 Bikes - 2" Hitches #SH22B will work great with your 2023 Land Rover Defender with a spare tire on the rear. This bike rack also will give you the ability to carry up to 2 bikes that weigh up to 40-lbs…

view full answer...

Answer 3

You can definitely use a hitch extender with the Thule Apex Swing XT, part #TH9027XT. The Apex Swing XT has 7-1/4" of clearance from the center of the hitch pin hole to the closest part of the rack. So, you only need about 7" more inches of…

view full answer...

Answer 4

Yes, the Thule Snug Tite Hitch Lock and Anti-Rattle Device part #THSTL2 is a M12x1.75". It's the same pin used for all Thule hitch mount bike racks.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 10

I recommend the Roadmaster Dual Hitch Receiver Adapter, 10" Drop/Rise item #RM-077-10. This adapter was designed for this type of set up. Your Jeep Rubicon and Swagman E bike rack weigh well below the 10,000 lbs maximum capacity of this hitch. I…

view full answer...

Answer 11

To me it makes the most sense to put a Bike Rack #HLY64FR on the flat towed vehicle rather than above the tow bars. Especially on heavy e-bikes as they are difficult to lift that high onto the rack, but also as it only makes sense to have the rack on…

view full answer...

Answer 12

Generally speaking wheel mount only bike racks are preferred. Especially for people with carbon fiber bike frames since frame mounts aren't recommended at all with them otherwise damage could occur. For other frame designs people still prefer…

view full answer...

What is the Size of the Anti-Rattle Bolt for the Thule Roadway 2 Bike Rack TH912XTR

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching